CT-1205H CUI Inc, CT-1205H Datasheet - Page 3

• Manufacturer Part Number: CT-1205H
• Description: BUZZER AUDIO MAGNETIC 5VP-P SMD
• Manufacturer: CUI Inc
• Series: CTr
• Type: Magnetic Transducer, External Driver

Specifications of CT-1205H

• Frequency: 2.4kHz
• Voltage - Rated: 5Vo-p
• Current Rating: 60mA
• Size / Dimension: Square - 12.8mm L x 12.8mm W x 10mm H
• Mounting Type: Surface Mount
• Sound Pressure Level: 88dB
• Operating Mode: Continuous
• Voltage Range: 3 ~ 7Vo-p
• Termination: Solder Pads
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Capacitance @ Frequency: -
• Other names: 102-1266-2

PART NUMBER:
MECHANICAL CHARACTERISTICS
item
soldering
soldering heat resistance
terminal mechanical strength
vibration test
drop test
ENVIRONMENT TEST
item
high temperature test
low temperature test
thermal shock test
temperature cycle test
20050 SW 112
CT-1205H
th
Ave. Tualatin, Oregon 97062
test condition
Lead terminals are immersed in a solder bath of +270 ±5°C for
3 ±1 seconds.
The product follows the reflow temperature curve to test its reflow
thermo stability.
For 10 seconds, the force of 9.8 N (1.0 kg) is applied to each
terminal in each axial direction.
The buzzer should be measured after a vibration amplitude of 1.5
mm with 10 ~ 55 Hz band of vibration frequency to each of the
3 perpendicular directions for 2 hours.
The buzzer without packaging is subjected to 3 drops on each
axis from the height of 75 cm onto a 40 mm thick wooden board.
test condition
After being placed in a chamber at +85°C for 96 hours.
After being placed in a chamber at -40°C for 96 hours.
The part will be subjected to 10 cycles. One cycle will consist of:
The part will be subjected to 10 cycles. One cycle will consist of:
+85
+25
3hrs
a
DESCRIPTION:
-40
30 min.
12±0.5hrs
b
24hours
60 min.
phone [phone]
3hrs
30 min.
+85
c
MAGNETIC BUZZER
a,b : 90~98%RH
c : 80~98%RH
fax [phone] www.cui.com
evaluation standard
90% min. of the lead terminals will be
wet with solder.
No interference in operation.
No damage or cutting off
After any tests, the buzzer will meet
specifications without any damage
in appearance and the SPL should be
within ±10% of the initial
measurements.
evaluation standard
After any tests, the buzzer will meet
specifications without any damage in
appearance except SPL. After
4 hours, SPL should be within ±10% of
the initial measurements.
date
page
03/2010
3 of 5