M30626FJPFP#U5C Renesas Electronics America, M30626FJPFP#U5C Datasheet - Page 257

• Manufacturer Part Number: M30626FJPFP#U5C
• Description: IC M16C MCU FLASH 512K 100QFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/60r

Specifications of M30626FJPFP#U5C

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: I²C, IEBus, UART/USART
• Peripherals: DMA, WDT
• Number Of I /o: 85
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 31K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 26x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 100-QFP
• For Use With: 867-1000 - KIT QUICK START RENESAS 62PR0K33062PS001BE - R0K33062P STARTER KITR0K33062PS000BE - KIT EVAL STARTER FOR M16C/62PM3062PT3-CPE-3 - EMULATOR COMPACT M16C/62P/30P
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

M16C/62P Group (M16C/62P, M16C/62PT)
Rev.2.41
REJ09B0185-0241
18.1.2
Table 18.3
NOTES:
Function
A/D Conversion Start
Condition
A/D Conversion Stop
Condition
Interrupt Request
Generation timing
Analog Input Pin
Reading of Result of A/D
Converter
1. If VCC2 < VCC1, do not use AN0_0 to AN0_7 and AN2_0 to AN2_7 as analog input pins.
In repeat mode, analog voltage applied to a selected pin is repeatedly converted to a digital code. Table 18.3
shows the Repeat Mode Specifications. Figure 18.6 shows the ADCON0 and ADCON1 Registers (Repeat
Mode).
Jan 10, 2006
Repeat Mode
Item
Repeat Mode Specifications
(1)
Page 240 of 390
The CH2 to CH0 bits in the ADCON0 register, the ADGSEL1 to ADGSEL0 bits
in the ADCON2 register and the OPA1 to OPA0 bits in the ADCON1 register
select a pin. Analog voltage applied to this pin is repeatedly converted to a
digital code.
• When the TRG bit in the ADCON0 register is “0” (software trigger)
• When the TRG bit is “1” (ADTRG trigger)
Set the ADST bit to “0” (A/D conversion halted)
None generated
Select one pin from AN0 to AN7, AN0_0 to AN0_7, AN2_0 to AN2_7,
ANEX0 to ANEX1
Read one of the AD0 to AD7 registers that corresponds to the selected pin
The ADST bit in the ADCON0 register is set to “1” (A/D conversion starts)
Input on the ADTRG pin changes state from high to low after the ADST bit is
set to “1” (A/D conversion starts)
Specification
18. A/D Converter