MC68HC908QT2CFQ Freescale Semiconductor, MC68HC908QT2CFQ Datasheet - Page 35

no-image

MC68HC908QT2CFQ

Manufacturer Part Number
MC68HC908QT2CFQ
Description
MCU 8-BIT 1536V FLASH 8-DFN
Manufacturer
Freescale Semiconductor
Series
HC08r
Datasheet

Specifications of MC68HC908QT2CFQ

Core Processor
HC08
Core Size
8-Bit
Speed
8MHz
Peripherals
LVD, POR, PWM
Number Of I /o
5
Program Memory Size
1.5KB (1.5K x 8)
Program Memory Type
FLASH
Ram Size
128 x 8
Voltage - Supply (vcc/vdd)
2.7 V ~ 5.5 V
Oscillator Type
Internal
Operating Temperature
-40°C ~ 85°C
Package / Case
8-DFN
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Eeprom Size
-
Data Converters
-
Connectivity
-
2.6.3 FLASH Mass Erase Operation
Use the following procedure to erase the entire FLASH memory to read as a 1:
2.6.4 FLASH Program Operation
Programming of the FLASH memory is done on a row basis. A row consists of 32 consecutive bytes
starting from addresses $XX00, $XX20, $XX40, $XX60, $XX80, $XXA0, $XXC0, or $XXE0. Use the
following step-by-step procedure to program a row of FLASH memory
Figure 2-4
Freescale Semiconductor
10. After time, t
1. When in monitor mode, with security sequence failed (see
1. Set both the ERASE bit and the MASS bit in the FLASH control register.
2. Read the FLASH block protect register.
3. Write any data to any FLASH address
4. Wait for a time, t
5. Set the HVEN bit.
6. Wait for a time, t
7. Clear the ERASE and MASS bits.
8. Wait for a time, t
9. Clear the HVEN bit.
1. Set the PGM bit. This configures the memory for program operation and enables the latching of
2. Read the FLASH block protect register.
3. Write any data to any FLASH location within the address range desired.
4. Wait for a time, t
5. Set the HVEN bit.
6. Wait for a time, t
7. Write data to the FLASH address being programmed
instead of any FLASH address.
address and data for programming.
shows a flowchart of the programming algorithm.
Mass erase is disabled whenever any block is protected (FLBPR does not
equal $FF).
Programming and erasing of FLASH locations cannot be performed by
code being executed from the FLASH memory. While these operations
must be performed in the order as shown, but other unrelated operations
may occur between the steps.
A mass erase will erase the internal oscillator trim values at $FFC0 and
$FFC1.
Only bytes which are currently $FF may be programmed.
RCV
(typical 1 μs), the memory can be accessed in read mode again.
NVS
MErase
NVHL
NVS
PGS
(minimum 10 μs).
(minimum 10 μs).
(minimum 5 μs).
(minimum 100 μs).
(minimum 4 ms).
MC68HC908QY/QT Family Data Sheet, Rev. 6
(1)
CAUTION
within the FLASH memory address range.
NOTE
NOTE
NOTE
15.3.2
Security), write to the FLASH block protect register
(2)
.
FLASH Memory (FLASH)
35

Related parts for MC68HC908QT2CFQ