MC68HC711D3CFNE3 Freescale Semiconductor, MC68HC711D3CFNE3 Datasheet - Page 26

• Manufacturer Part Number: MC68HC711D3CFNE3
• Description: IC MCU 8BIT 2MHZ 44-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC711D3CFNE3

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 3MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 26
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: OTP
• Ram Size: 192 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 44-PLCC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -

3.1.6.8 Stop Disable (S)
3.2 Data Types
3.3 Opcodes and Operands
3.4 Addressing Modes
3-6
terrupt occurred. The X interrupt mask bit is set only by hardware (or acknowledge). X
is cleared only by program instruction (TAP, where the associated bit of A is 0; or RTI,
where bit 6 of the value loaded into the CCR from the stack has been cleared). There
is no hardware action for clearing X.
Setting the STOP disable (S) bit prevents the STOP instruction from putting the
M68HC11 into a low-power stop condition. If the STOP instruction is encountered by
the CPU while the S bit is set, it is treated as a no-operation (NOP) instruction, and
processing continues to the next instruction. S is set by reset —STOP disabled by de-
fault.
The M68HC11 CPU supports the following data types:
A byte is eight bits wide and can be accessed at any byte location. A word is composed
of two consecutive bytes with the most significant byte at the lower value address. Be-
cause the M68HC11 is an 8-bit CPU, there are no special requirements for alignment
of instructions or operands.
The M68HC11 family of microcontrollers uses 8-bit opcodes. Each opcode identifies
a particular instruction and associated addressing mode to the CPU. Several opcodes
are required to provide each instruction with a range of addressing capabilities. Only
256 opcodes would be available if the range of values were restricted to the number
able to be expressed in 8-bit binary numbers.
A four-page opcode map has been implemented to expand the number of instructions.
An additional byte, called a prebyte, directs the processor from page 0 of the opcode
map to one of the other three pages. As its name implies, the additional byte precedes
the opcode.
A complete instruction consists of a prebyte, if any, an opcode, and zero, one, two, or
three operands. The operands contain information the CPU needs for executing the
instruction. Complete instructions can be from one to five bytes long.
Six addressing modes; immediate, direct, extended, indexed, inherent, and relative,
detailed in the following paragraphs, can be used to access memory. All modes except
inherent mode use an effective address. The effective address is the memory address
from which the argument is fetched or stored, or the address from which execution is
• Bit data
• 8-bit and 16-bit signed and unsigned integers
• 16-bit unsigned fractions
• 16-bit addresses
Freescale Semiconductor, Inc.
For More Information On This Product,
CENTRAL PROCESSING UNIT
Go to: www.freescale.com
TECHNICAL DATA