MC68HC705C9ACFBE Freescale Semiconductor, MC68HC705C9ACFBE Datasheet - Page 71

• Manufacturer Part Number: MC68HC705C9ACFBE
• Description: IC MCU 8BIT 44-QFP
• Manufacturer: Freescale Semiconductor
• Series: HC05r

Specifications of MC68HC705C9ACFBE

• Core Processor: HC05
• Core Size: 8-Bit
• Speed: 2.1MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 24
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: OTP
• Ram Size: 352 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 44-QFP
• Processor Series: HC705C
• Core: HC05
• Data Bus Width: 8 bit
• Data Ram Size: 352 B
• Interface Type: SCI, SPI
• Maximum Clock Frequency: 2.1 MHz
• Number Of Programmable I/os: 31
• Number Of Timers: 1
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit
• Package: 44PQFP
• Family Name: HC05
• Maximum Speed: 2.1 MHz
• Operating Supply Voltage: 3.3|5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Lead Free Status / Rohs Status: Details

Chapter 10
Serial Peripheral Interface (SPI)
10.1 Introduction
The serial peripheral interface (SPI) is an interface built into the device which allows several MC68HC05
MCUs, or MC68HC05 MCU plus peripheral devices, to be interconnected within a single printed circuit
board. In an SPI, separate wires are required for data and clock. In the SPI format, the clock is not
included in the data stream and must be furnished as a separate signal. An SPI system may be configured
in one containing one master MCU and several slave MCUs, or in a system in which an MCU is capable
of being a master or a slave.
10.2 Features
Features include:
10.3 SPI Signal Description
The four basic signals (MOSI, MISO, SCK, and SS) are described in the following paragraphs. Each
signal function is described for both the master and slave modes.
Freescale Semiconductor
•
•
•
•
•
•
•
•
•
Full-duplex, four-wire synchronous transfers
Master or slave operation
Bus frequency divided by 2 (maximum) master bit frequency
Bus frequency (maximum) slave bit frequency
Four programmable master bit rates
Programmable clock polarity and phase
End of transmission interrupt flag
Write collision flag protection
Master-master mode fault protection capability
In C9A mode, any SPI output line has to have its corresponding data
direction register bit set. If this bit is clear, the line is disconnected from the
SPI logic and becomes a general-purpose input line. When the SPI is
enabled, any SPI input line is forced to act as an input regardless of what
is in the corresponding data direction register bit.
MC68HC05C9A Advance Information Data Sheet, Rev. 4.1
NOTE
71