UPD78F9212CS-CAB-A Renesas Electronics America, UPD78F9212CS-CAB-A Datasheet - Page 123

• Manufacturer Part Number: UPD78F9212CS-CAB-A
• Description: MCU 8BIT 4KB FLASH 16PIN
• Manufacturer: Renesas Electronics America
• Series: 78K0S/Kx1+r

Specifications of UPD78F9212CS-CAB-A

• Core Processor: 78K0S
• Core Size: 8-Bit
• Speed: 10MHz
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 13
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: FLASH
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Connectivity: -

(2) One-shot pulse output with external trigger
CR010 set value
CR000 set value
TO00 pin output
Caution 16-bit timer counter 00 starts operating as soon as a value other than 00 (operation stop
Remark N < M
A one-shot pulse can be output from the TO00 pin by setting 16-bit timer mode control register 00 (TMC00),
capture/compare control register 00 (CRC00), and 16-bit timer output control register 00 (TOC00) as shown in
Figure 6-35, and by using the valid edge of the TI000 pin as an external trigger.
The valid edge of the TI000 pin is specified by bits 4 and 5 (ES000, ES010) of prescaler mode register 00
(PRM00). The rising, falling, or both the rising and falling edges can be specified.
When the valid edge of the TI000 pin is detected, the 16-bit timer/event counter is cleared and started, and the
output becomes active at the count value set in advance to 16-bit timer capture/compare register 010
(CR010).
capture/compare register 000 (CR000)
Note The case where N < M is described here. When N > M, the output becomes active with the CR000
Caution Do not input the external trigger again while the one-shot pulse is output.
Count clock
TM00 count
INTTM010
INTTM000
OSPT00
register and inactive with the CR010 register. Do not set N to M.
Figure 6-34. Timing of One-Shot Pulse Output Operation with Software Trigger
To output the one-shot pulse again, wait until the current one-shot pulse output is
mode) is set to the TMC003 and TMC002 bits.
completed.
After that, the output becomes inactive at the count value set in advance to 16-bit timer
Set TMC00 to 04H
(TM00 count starts)
0000H
M
N
0001H
CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00
N
User’s Manual U16994EJ6V0UD
Note
N + 1
.
N
M
0000H
N
1
M
N
N
M
1
M
M
N
M + 1 M + 2
121