UPD78F9212CS-CAB-A Renesas Electronics America, UPD78F9212CS-CAB-A Datasheet - Page 241

• Manufacturer Part Number: UPD78F9212CS-CAB-A
• Description: MCU 8BIT 4KB FLASH 16PIN
• Manufacturer: Renesas Electronics America
• Series: 78K0S/Kx1+r

Specifications of UPD78F9212CS-CAB-A

• Core Processor: 78K0S
• Core Size: 8-Bit
• Speed: 10MHz
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 13
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: FLASH
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Connectivity: -

(4) Flash programming command register (FLCMD)
This register is used to specify whether the flash memory is erased, written, or verified in the self programming
mode.
This register is set by using a 1-bit or 8-bit memory manipulation instruction.
Reset signal generation clears this register to 00H.
Address: FFA3H
Note If any command other than those above is executed, command execution may immediately be
FLCMD
Symbol
Figure 16-13. Format of Flash Programming Command Register (FLCMD)
terminated, and bit 1 or 2 (WEPRERR or VCERR) of the flash status register (PFS) may be set to
1.
FLCMD2
7
0
0
0
0
1
1
Other than above
After reset: 00H
FLCMD1
6
0
0
1
1
0
0
CHAPTER 16 FLASH MEMORY
FLCMD0
Note
User’s Manual U16994EJ6V0UD
5
0
1
0
1
0
1
R/W
Internal verify 1
Internal verify 2
Block erase
Block blank check
Byte write
Setting prohibited
Command Name
4
0
3
0
This command is used to check if
data has been correctly written to the
flash memory. It is used to check
whether data has been written to an
entire block. If an error occurs, bit 1
(VCERR) or bit 2 (WEPRERR) of the
flash status register (PFS) is set to 1.
This command is used to check if
data has been correctly written to the
flash memory. It is used to check
whether data has been written to
multiple addresses in the same block.
If an error occurs, bit 1 (VCERR) or
bit 2 (WEPRERR) of the flash status
register (PFS) is set to 1.
This command is used to erase
specified block. It is used both in the
on-board mode and self
programming mode.
This command is used to check if the
specified block has been erased.
This command is used to write 1-byte
data to the specified address in the
flash memory. Specify the write
address and write data, then execute
this command.
If 1 is written to a bit that has not
been erased (a bit for which the data
is 0), then bit 2 (WEPRERR) of the
flash status register (PFS) becomes
1.
FLCMD2
2
Function
FLCMD1
1
FLCMD0
0
239