UPD78F1144AGB-GAH-AX Renesas Electronics America, UPD78F1144AGB-GAH-AX Datasheet - Page 112

• Manufacturer Part Number: UPD78F1144AGB-GAH-AX
• Description: MCU 16BIT 78K0R/KX3 64-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0R/Kx3r

Specifications of UPD78F1144AGB-GAH-AX

• Core Processor: 78K/0R
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 50
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

4.2.5 Port 4
port mode register 4 (PM4). When the P40 to P43 pins are used as an input port, use of an on-chip pull-up resistor
can be specified in 1-bit units by pull-up resistor option register 4 (PU4)
110
Cautions 1. When a tool is connected, the P40 pin cannot be used as a port pin.
Port 4 is a 4-bit I/O port with a output latch. Port 4 can be set to the input mode or output mode in 1-bit units using
This port can also be used for flash memory programmer/debugger data I/O, clock output, and timer I/O.
Reset signal generation sets port 4 to input mode.
Figures 4-14 to 4-17 show block diagrams of port 4.
Note When a tool is connected, the P40 and P41 pins cannot be connected to a pull-up resistor.
2. To use P42/TI04/TO04 as a general-purpose port, set bit 4 (TO04) of timer output register 0
When the on-chip debug function is used, P41 pin can be used as follows by the mode setting
on the debugger.
(TO0) and bit 4 (TOE04) of timer output enable register 0 (TOE0) to “0”, which is the same as
their default status setting.
1-line mode: can be used as a port (P41).
2-line mode: used as a TOOL1 pin and cannot be used as a port (P41).
CHAPTER 4 PORT FUNCTIONS
User’s Manual U17854EJ9V0UD
Note
.