UPD78F1144AGB-GAH-AX Renesas Electronics America, UPD78F1144AGB-GAH-AX Datasheet - Page 184

• Manufacturer Part Number: UPD78F1144AGB-GAH-AX
• Description: MCU 16BIT 78K0R/KX3 64-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0R/Kx3r

Specifications of UPD78F1144AGB-GAH-AX

• Core Processor: 78K/0R
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 50
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

6.1.2 Functions of each channel when it operates with another channel
reference timer that controls cycles) and the slave channels (timers that operate following the master channel) in
combination (for details, refer to 6.6.1 Overview of single-operation function and combination-operation
function).
6.1.3 LIN-bus supporting function (channel 7 only)
182
Combination-operation functions are those functions that are attained by using the master channel (mostly the
(1) PWM (Pulse Width Modulator) output
(2) One-shot pulse output
(3) Multiple PWM (Pulse Width Modulator) output
(1) Detection of wakeup signal
(2) Detection of sync break field
(3) Measurement of pulse width of sync field
Two channels are used as a set to generate a pulse with a specified period and a specified duty factor.
Two channels are used as a set to generate a one-shot pulse with a specified delay time and a specified pulse
width.
By extending the PWM function and using one master channel and two or more slave channels, up to seven
types of PWM signals that have a specific period and a specified duty factor can be generated.
The timer starts counting at the falling edge of a signal input to the serial data input pin (RxD3) of UART3 and
the count value of the timer is captured at the rising edge. In this way, a low-level width can be measured. If
the low-level width is greater than a specific value, it is recognized as a wakeup signal.
The timer starts counting at the falling edge of a signal input to the serial data input pin (RxD3) of UART3 after
a wakeup signal is detected, and the count value of the timer is captured at the rising edge. In this way, a low-
level width is measured. If the low-level width is greater than a specific value, it is recognized as a sync break
field.
After a sync break field is detected, the low-level width and high-level width of the signal input to the serial
data input pin (RxD3) of UART3 are measured. From the bit interval of the sync field measured in this way, a
baud rate is calculated.
CHAPTER 6 TIMER ARRAY UNIT
User’s Manual U17854EJ9V0UD