TS80C51RA2-VCA Atmel, TS80C51RA2-VCA Datasheet - Page 55

• Manufacturer Part Number: TS80C51RA2-VCA
• Description: IC MCU 8BIT 256BYTE 40MHZ 40-DIP
• Manufacturer: Atmel
• Series: 80Cr

Specifications of TS80C51RA2-VCA

• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 40/30MHz
• Connectivity: UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 32
• Program Memory Type: ROMless
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 40-DIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

9.3.3
9.3.4
4188F–8051–01/08
* See Table 31. for proper value on these inputs
Programming Algorithm
Verify algorithm
PROGRAM SIGNALS*
CONTROL SIGNALS*
Figure 9-1.
The Improved Quick Pulse algorithm is based on the Quick Pulse algorithm and decreases the
number of pulses applied during byte programming from 25 to 1.
To program the TS87C51RB2/RC2/RD2 the following sequence must be exercised:
Repeat step 2 through 6 changing the address and data for the entire array or until the end of
the object file is reached (See
Code array verify must be done after each byte or block of bytes is programmed. In either case,
a complete verify of the programmed array will ensure reliable programming of the
TS87C51RB2/RC2/RD2.
P 2.7 is used to enable data output.
To verify the TS87C51RB2/RC2/RD2 code the following sequence must be exercised:
Repeat step 2 through 3 changing the address for the entire array verification (See Figure 9-2.)
• Step 1: Activate the combination of control signals.
• Step 2: Input the valid address on the address lines.
• Step 3: Input the appropriate data on the data lines.
• Step 4: Raise EA/VPP from VCC to VPP (typical 12.75V).
• Step 5: Pulse ALE/PROG once.
• Step 6: Lower EA/VPP from VPP to VCC
• Step 1: Activate the combination of program and control signals.
• Step 2: Input the valid address on the address lines.
• Step 3: Read data on the data lines.
4 to 6 MHz
Set-Up Modes Configuration
EA/VPP
ALE/PROG
RST
PSEN
P2.6
P2.7
P3.3
P3.6
P3.7
XTAL1
Figure
P2.0-P2.5
P3.4-P3.5
9-2).
P0.0-P0.7
P1.0-P1.7
VCC
VSS
GND
+5V
D0-D7
A0-A7
A8-A15
AT/TS8xC51Rx2
55