MC68HC705B16CFN Freescale Semiconductor, MC68HC705B16CFN Datasheet - Page 110

no-image

MC68HC705B16CFN

Manufacturer Part Number
MC68HC705B16CFN
Description
IC MCU 2.1MHZ 15K OTP 52-PLCC
Manufacturer
Freescale Semiconductor
Series
HC05r
Datasheet

Specifications of MC68HC705B16CFN

Core Processor
HC05
Core Size
8-Bit
Speed
2.1MHz
Connectivity
SCI
Peripherals
POR, WDT
Number Of I /o
32
Program Memory Size
15KB (15K x 8)
Program Memory Type
OTP
Eeprom Size
256 x 8
Ram Size
352 x 8
Voltage - Supply (vcc/vdd)
4.5 V ~ 5.5 V
Data Converters
A/D 8x8b
Oscillator Type
Internal
Operating Temperature
-40°C ~ 85°C
Package / Case
52-PLCC
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MC68HC705B16CFN
Manufacturer:
MOT
Quantity:
5 510
Part Number:
MC68HC705B16CFN
Manufacturer:
MOT
Quantity:
2 132
Part Number:
MC68HC705B16CFN
Manufacturer:
FREESCALE
Quantity:
20 000
Part Number:
MC68HC705B16CFNE
Manufacturer:
FREESCALE
Quantity:
2 512
9
9.2
The MCU can be interrupted by four different sources: three maskable hardware interrupts and
one non maskable software interrupt:
Interrupts cause the processor to save the register contents on the stack and to set the interrupt
mask (I-bit) to prevent additional interrupts. The RTI instruction (ReTurn from Interrupt) causes the
register contents to be recovered from the stack and normal processing to resume. While
executing the RTI instruction, the value of the I-bit is replaced by the corresponding I-bit stored on
the stack.
Unlike reset, hardware interrupts do not cause the current instruction execution to be halted, but
are considered pending until the current instruction is complete. The current instruction is the one
already fetched and being operated on. When the current instruction is complete, the processor
checks all pending hardware interrupts. If interrupts are not masked (I-bit clear) and the
corresponding interrupt enable bit is set, the processor proceeds with interrupt processing;
otherwise, the next instruction is fetched and executed.
Note:
9.2.1
Each potential interrupt source is assigned a priority level, which means that if more than one
interrupt is pending at the same time, the processor will service the one with the highest priority
first. For example, if both an external interrupt and a timer interrupt are pending after an instruction
execution, the external interrupt is serviced first.
Table 9-2
the interrupt processing flow.
9.2.2
The software interrupt (SWI) is an executable instruction and a nonmaskable interrupt: it is
executed regardless of the state of the I-bit in the CCR. If the I-bit is zero (interrupts enabled), SWI
is executed after interrupts that were pending when the SWI was fetched, but before interrupts
Freescale
9-6
External signal on the IRQ pin
Serial communications interface (SCI)
Programmable timer
Software interrupt instruction (SWI)
shows the relative priority of all the possible interrupt sources.
Power-on and external reset clear all interrupt enable bits, but set the INTE bit in the
miscellaneous register, thus preventing interrupts during the reset sequence.
Interrupts
Interrupt priorities
Nonmaskable software interrupt (SWI)
RESETS AND INTERRUPTS
Figure 9-3
MC68HC05B6
Rev. 4.1
shows

Related parts for MC68HC705B16CFN