MC68HC705B16CFN Freescale Semiconductor, MC68HC705B16CFN Datasheet - Page 259

no-image

MC68HC705B16CFN

Manufacturer Part Number
MC68HC705B16CFN
Description
IC MCU 2.1MHZ 15K OTP 52-PLCC
Manufacturer
Freescale Semiconductor
Series
HC05r
Datasheet

Specifications of MC68HC705B16CFN

Core Processor
HC05
Core Size
8-Bit
Speed
2.1MHz
Connectivity
SCI
Peripherals
POR, WDT
Number Of I /o
32
Program Memory Size
15KB (15K x 8)
Program Memory Type
OTP
Eeprom Size
256 x 8
Ram Size
352 x 8
Voltage - Supply (vcc/vdd)
4.5 V ~ 5.5 V
Data Converters
A/D 8x8b
Oscillator Type
Internal
Operating Temperature
-40°C ~ 85°C
Package / Case
52-PLCC
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MC68HC705B16CFN
Manufacturer:
MOT
Quantity:
5 510
Part Number:
MC68HC705B16CFN
Manufacturer:
MOT
Quantity:
2 132
Part Number:
MC68HC705B16CFN
Manufacturer:
FREESCALE
Quantity:
20 000
Part Number:
MC68HC705B16CFNE
Manufacturer:
FREESCALE
Quantity:
2 512
E6LAT — EPROM programming latch enable bit
STOP, power-on and external reset clear the E6LAT bit.
Note:
E6PGM — EPROM program enable bit
This bit is the EPROM program enable bit. It can be set to ‘1’ to enable programming only after
E6LAT is set and at least one byte is written to the EPROM. It is not possible to clear this bit using
software but clearing E6LAT will always clear E6PGM.
Note:
ECLK
See
E1ERA — EEPROM erase/programming bit
Providing the E1LAT and E1PGM bits are at logic one, this bit indicates whether the access to the
EEPROM is for erasing or programming purposes.
Once the program/erase EEPROM address has been selected, E1ERA cannot be changed.
MC68HC05B6
Rev. 4.1
Section
1 (set)
0 (clear) –
1 (set)
0 (clear) –
After the t
to zero in order to clear the E6PGM bit.
All combinations are not shown in the above table, since the E6PGM bit is cleared when
the E6LAT bit is at zero, and will result in a read condition.
4.3.
ERA1
Address and up to sixteen data bytes can be latched into the EPROM
for further programming providing the E6PGM bit is cleared. When
programming the EPROM, all other 15 addresses must be latched
with the erased state ($00) or corruption may occur.
Data can be read from the EPROM or firmware ROM; the E6PGM bit
is reset to zero when E6LAT is ‘0’.
An erase operation will take place.
A programming operation will take place.
E6LAT E6PGM
0
1
1
erase time or t
Table H-2 EPROM control bits description
0
0
1
Read/execute in EPROM
Ready to write address/data to EPROM
programming in progress
MC68HC705B32
PROG1
programming time, the E6LAT bit has to be reset
Description
Freescale
H-9
14

Related parts for MC68HC705B16CFN