MC68HC11E1CFN3 Freescale Semiconductor, MC68HC11E1CFN3 Datasheet - Page 25

• Manufacturer Part Number: MC68HC11E1CFN3
• Description: IC MCU 3MHZ 512 EEPROM 52-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC11E1CFN3

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 3MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 38
• Program Memory Type: ROMless
• Eeprom Size: 512 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 52-PLCC
• Data Bus Width: 8 bit
• Data Ram Size: 512 B
• Interface Type: SCI, SPI
• Maximum Clock Frequency: 3 MHz
• Number Of Programmable I/os: 22
• Number Of Timers: 16 bit
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Program Memory Size: -
• Lead Free Status / Rohs Status: Details

1.4.4 E-Clock Output (E)
1.4.5 Interrupt Request (IRQ)
M68HC11E Family — Rev. 5
MOTOROLA
CAUTION:
In all cases, use caution around the oscillator pins. Load capacitances shown in the
oscillator circuit are specified by the crystal manufacturer and should include all
stray layout capacitances.
E is the output connection for the internally generated E clock. The signal from E
is used as a timing reference. The frequency of the E-clock output is one fourth that
of the input frequency at the XTAL and EXTAL pins. When E-clock output is low,
an internal process is taking place. When it is high, data is being accessed.
All clocks, including the E clock, are halted when the MCU is in stop mode. To
reduce RFI emissions, the E-clock output of most E-series devices can be disabled
while operating in single-chip modes.
The E-clock signal is always enabled on the MC68HC811E2.
The IRQ input provides a means of applying asynchronous interrupt requests to the
MCU. Either negative edge-sensitive triggering or level-sensitive triggering is
program selectable (OPTION register). IRQ is always configured to level-sensitive
triggering at reset. When using IRQ in a level-sensitive wired-OR configuration,
connect an external pullup resistor, typically 4.7 kΩ, to V
Freescale Semiconductor, Inc.
Figure 1-9. Common Parallel Resonant Crystal Connections
For More Information On This Product,
MCU
Figure 1-10. External Oscillator Connections
Go to: www.freescale.com
MCU
EXTAL
XTAL
EXTAL
General Description
XTAL
NC
10 MΩ
EXTERNAL OSCILLATOR
CRYSTAL
CMOS-COMPATIBLE
4 x E
4 x E
DD
C
C
L
L
.
General Description
Pin Descriptions
Data Sheet
25