MC68HC11E1CFN3 Freescale Semiconductor, MC68HC11E1CFN3 Datasheet - Page 265

• Manufacturer Part Number: MC68HC11E1CFN3
• Description: IC MCU 3MHZ 512 EEPROM 52-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC11E1CFN3

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 3MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 38
• Program Memory Type: ROMless
• Eeprom Size: 512 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 52-PLCC
• Data Bus Width: 8 bit
• Data Ram Size: 512 B
• Interface Type: SCI, SPI
• Maximum Clock Frequency: 3 MHz
• Number Of Programmable I/os: 22
• Number Of Timers: 16 bit
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Program Memory Size: -
• Lead Free Status / Rohs Status: Details

Step 3
Step 4
Step 5
Step 8
EB296
MOTOROLA
You are now ready to download your program into the EPROM.
After the programming operation is complete, PCbug11 will display this
message
•
•
•
•
•
Freescale Semiconductor, Inc.
For More Information On This Product,
PCbug11 defaults to base 10 for its input parameters; change this
to hexadecimal by typing
You must declare the addresses of the EPROM array to PCbug11.
To do this, type
Connect +12 volts (at most +12.5 volts) through a 100-Ω current
limiting resistor to P4 connector pin 18, the XIRQ* pin.
At the PCbug11 command prompt type
You should now remove the programming voltage from P4
connector pin 18, the XIRQ* pin.
Substitute the name of your program into the command above.
Use a full path name if your program is not located in the same
directory as PCbug11.
Each ORG directive in your assembly language source will cause
a pair of these lines to be generated. For this operation, $yyyy will
be incremented by the size of each block of code programmed
into the EPROM of the MC68HC711E9.
Go to: www.freescale.com
LOADS C:\MYPROG\ISHERE.S19
Total bytes programmed: $yyyy
Total bytes loaded: $xxxx
CONTROL BASE HEX
EPROM D000 FFFF
Engineering Bulletin
265