MC68HC711K4CFN4 Freescale Semiconductor, MC68HC711K4CFN4 Datasheet - Page 230

• Manufacturer Part Number: MC68HC711K4CFN4
• Description: IC MCU 24K OTP 4MHZ 84-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC711K4CFN4

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 4MHz
• Connectivity: SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 62
• Program Memory Size: 24KB (24K x 8)
• Program Memory Type: OTP
• Eeprom Size: 640 x 8
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 84-PLCC
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Analog-to-Digital (A/D) Converter
10.5 Design Considerations
10.5.1 A/D Input Pins
10.5.2 Operation in Stop and Wait Modes
Technical Data
230
Note 1. This analog switch is closed only during the 12-cycle sample time.
ANALOG
INPUT
PIN
Figure 10-6. Electrical Model of an A/D Input Pin (Sample Mode)
PROTECTION
< 2 pF
DEVICE
INPUT
This section discusses design considerations.
Port E pins can also be used as general-purpose digital inputs. Digital
reads of port E pins are not recommended during the sample portion of
an A/D conversion cycle, when the gate signal to the N-channel input is
on. No P-channel devices are directly connected to either input pins or
reference voltage pins, so voltages above V
problem, although current should be limited according to maximum
ratings. Refer to
If a conversion sequence is in progress when either the stop or wait
mode is entered, the conversion of the current channel is suspended.
When the MCU resumes normal operation, that channel is resampled
and the conversion sequence is resumed. As the MCU exits the wait
mode, the A/D circuits are stable and valid results can be obtained on
the first conversion. However, in stop mode, all analog bias currents are
disabled and it is necessary to allow a stabilization period when leaving
stop mode. If stop mode is exited with a delay (DLY = 1), there is enough
time for these circuits to stabilize before the first conversion. If stop mode
is exited with no delay (DLY bit in OPTION register = 0), allow 10 ms for
the A/D circuitry to stabilize to avoid invalid results.
Freescale Semiconductor, Inc.
For More Information On This Product,
+ ~20 V
– ~0.7 V
Analog-to-Digital (A/D) Converter
Go to: www.freescale.com
+ ~12 V
– ~0.7 V
Figure
DUMMY N-CHANNEL
OUTPUT DEVICE
10-6.
DIFFUSION/POLY
JUNCTION
LEAKAGE
COUPLER
400 nA
4 k
DD
do not cause a latchup
~ 20 pF
*
SEE NOTE 1
V
RL
M68HC11K Family
CAPACITANCE
DAC
MOTOROLA