MC68HC11E0CFNE2 Freescale Semiconductor, MC68HC11E0CFNE2 Datasheet - Page 147

• Manufacturer Part Number: MC68HC11E0CFNE2
• Description: IC MCU 8BIT 2MHZ 52-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC11E0CFNE2

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 2MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 38
• Program Memory Type: ROMless
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 52-PLCC
• Controller Family/series: 68HC11
• No. Of I/o's: 38
• Ram Memory Size: 512Byte
• Cpu Speed: 2MHz
• No. Of Timers: 1
• Embedded Interface Type: SCI, SPI
• Digital Ic Case Style: LCC
• Rohs Compliant: Yes
• Processor Series: HC11E
• Core: HC11
• Data Bus Width: 8 bit
• Data Ram Size: 512 B
• Interface Type: SCI, SPI
• Maximum Clock Frequency: 2 MHz
• Number Of Programmable I/os: 38
• Number Of Timers: 8
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit, 8 Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -
• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device

PAII and PAIF — Pulse Accumulator Input Edge Interrupt Enable Bit and Flag
Freescale Semiconductor
The PAIF status bit is automatically set each time a selected edge is detected at the PA7/PAI/OC1 pin.
To clear this status bit, write to the TFLG2 register with a 1 in the corresponding data bit position (bit
4). The PAII control bit allows configuring the pulse accumulator input edge detect for polled or
interrupt-driven operation but does not affect setting or clearing the PAIF bit. When PAII is 0, pulse
accumulator input interrupts are inhibited, and the system operates in a polled mode. In this mode, the
PAIF bit must be polled by user software to determine when an edge has occurred. When the PAII
control bit is set, a hardware interrupt request is generated each time PAIF is set. Before leaving the
interrupt service routine, software must clear PAIF by writing to the TFLG2 register.
M68HC11E Family Data Sheet, Rev. 5.1
Pulse Accumulator
147