M30626FJPFP#D5C Renesas Electronics America, M30626FJPFP#D5C Datasheet - Page 259

• Manufacturer Part Number: M30626FJPFP#D5C
• Description: MCU 3/5V 512K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/60r

Specifications of M30626FJPFP#D5C

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: I²C, IEBus, UART/USART
• Peripherals: DMA, WDT
• Number Of I /o: 85
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 31K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 26x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

M16C/62P Group (M16C/62P, M16C/62PT)
Rev.2.41
REJ09B0185-0241
18.1.3
Table 18.4
NOTES:
Function
A/D Conversion Start
Condition
A/D Conversion Stop
Condition
Interrupt Request
Generation timing
Analog Input Pin
Reading of Result of A/D
Converter
1. AN0_0 to AN0_7, and AN2_0 to AN2_7 can be used in the same way as AN0 to AN7. However, if
In single sweep mode, analog voltage that is applied to selected pins is converted one-by-one to a digital code.
Table 18.4 shows the Single Sweep Mode Specifications. Figure 18.7 shows the ADCON0 Register and
ADCON1 Register (Single Sweep Mode).
VCC2 < VCC1, do not use AN0_0 to AN0_7 and AN2_0 to AN2_7 as analog input pins.
Jan 10, 2006
Single Sweep Mode
Item
Single Sweep Mode Specifications
Page 242 of 390
The SCAN1 to SCAN0 bits in the ADCON1 register and the ADGSEL1 to
ADGSEL0 bits in the ADCON2 register select pins. Analog voltage applied to
this pins is converted one-by-one to a digital code.
• When the TRG bit in the ADCON0 register is “0” (software trigger)
• When the TRG bit is “1” (ADTRG trigger)
• Completion of A/D conversion (If a software trigger is selected, the ADST bit
• Set the ADST bit to “0”
Completion of A/D conversion
Select from AN0 to AN1 (2 pins), AN0 to AN3 (4 pins), AN0 to AN5 (6 pins),
AN0 to AN7 (8 pin)
Read one of the AD0 to AD7 registers that corresponds to the selected pin
is cleared to “0” (A/D conversion halted))
The ADST bit in the ADCON0 register is set to “1” (A/D conversion starts)
Input on the ADTRG pin changes state from high to low after the ADST bit is
set to “1” (A/D conversion starts)
(1)
Specification
18. A/D Converter