SP0408LE5H-SB Knowles Acoustics, SP0408LE5H-SB Datasheet

Page 1

... Amplified “Zero Height” SiSonic™ Microphone with Enhanced RF Specification Knowles Acoustics 1151 Maplewood Drive Itasca, IL 60143 Knowles Acoust ics, a division of Knowles Elect r onics, LLC. SP0208LE5 Revision ...

Page 2

DESCRIPTION AND APPLICATION 1.1 Description Amplified “Zero Height” Surface Mount Silicon Microphone with Enhanced RF Protection 1.2 Application Hand held telecommunication devices 2. PART MARKING Identification Number Pin 1 3. TEMPERATURE RANGE 3.1 Operating Temperature Range: -40°C to +100°C ...

Page 3

ACOUSTIC & ELECTRICAL SPECIFICATIONS Test Conditions: +20°C, 60-70% R.H. Symbol Directivity Sensitivity S Output impedance Z OUT Current Consumption I DSS Signal to Noise Ratio S/N Supply Voltage Vs Typical Input Referred ENL Noise Sensitivity Loss across Voltage Maximum ...

Page 4

MECHANICAL SPECIFICATIONS Pin Output Pin # Function 1 Output 2 Gain Control 3 Ground 4 Power Knowles Acoust ics, a division of Knowles SP0208LE5 Item Dim. Height 1.25 Length 6.15 Width 3.76 Weight 0.09 Coplanarity ...

Page 5

RECOMMENDED CUSTOMER LAND PATTERN Knowles Acoust ics, a division of Knowles SP0208LE5 Elect r onics, LLC. Revision ...

Page 6

RECOMMENDED SOLDER STENCIL PATTERN     Notes: • The design requires that an acoustic seal be established between the SiSonic and customer PCB. This is accomplished via a solder seal. • Solder Stencil Thickness = 0.127 min ...

Page 7

RECOMMENDED INTERFACE CIRCUIT V+ Term Term 3 = Ground D e sir Pin ina t ion hod Unit y Gain ( 0dB) Tie Term ...

Page 8

PACKAGING DETAIL Reel Model Number Suffix Diameter SP0208LE5 -2 SP0208LE5 -6 13” Knowles Acoust ics, a division of Knowles Qty per Tape & Reel Reel Leader Length 7” 1,200 Label 4,800 Empty Units Elect r onics, LLC. SP0208LE5 Pin ...

Page 9

SOLDER REFLOW PROFILE 170–180° C Stage Pre-heat Solder Melt Peak Notes not pull a vacuum over the port hole of the microphone. Pulling a vacuum over the port hole can damage the device not board ...

Page 10

RELIABILITY SPECIFICATIONS Note: After test conditions are performed, the sensitivity of the microphone shall not deviate more than 3dB from its initial value. Test Thermal Shock Microphone unit must operate when exposed to air-to-air thermal shock 100 cycles, from ...

Page 11

SPECIFICATION REVISIONS Revision Detailed Specification Changes A Preliminary Specification - Initial Release B Knowles Acoust ics, a division of Knowles SP0208LE5 Specification Release Elect r onics, LLC. Date 06-10-2006 08-03-2006 Revision ...