LM258ADT STMicroelectronics, LM258ADT Datasheet - Page 3

• Manufacturer Part Number: LM258ADT
• Description: IC OP AMP DUAL LOW POWER 8-SOIC
• Manufacturer: STMicroelectronics

Specifications of LM258ADT

• Amplifier Type: General Purpose
• Number Of Circuits: 2
• Slew Rate: 0.6 V/µs
• Gain Bandwidth Product: 1.1MHz
• Current - Input Bias: 20nA
• Voltage - Input Offset: 1000µV
• Current - Supply: 700µA
• Current - Output / Channel: 60mA
• Voltage - Supply, Single/dual (±): 3 V ~ 30 V, ±1.5 V ~ 15 V
• Operating Temperature: -40°C ~ 105°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• -3db Bandwidth: -
• Other names: 497-7327-2; LM258ADT

LM158-LM258-LM358
2
Absolute maximum ratings
Table 1.
1. Short-circuits from the output to V
2. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the
3. Short-circuits can cause excessive heating and destructive dissipation. R
4. Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a
5. Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between
6. Charged device model: all pins and the package are charged together to the specified voltage and then
Symbol
T
R
ESD
R
V
T
current is approximately 40 mA independent of the magnitude of V
from simultaneous short circuits on all amplifiers.
collector-base junction of the input PNP transistor becoming forward-biased and thereby acting as input
diode clamp. In addition to this diode action, there is NPN parasitic action on the IC chip. This transistor
action can cause the output voltages of the Op-amps to go to the V
overdrive) for the time during which an input is driven negative.
This is not destructive and normal output is restored for input voltages above -0.3 V.
1.5 kΩ resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
two pins of the device with no external series resistor (internal resistor < 5 Ω). This is done for all couples of
connected pin combinations while the other pins are floating.
discharged directly to the ground through only one pin. This is done for all pins.
V
oper
V
I
T
CC
thja
thjc
stg
in
id
j
i
Supply voltage
Input voltage
Differential input voltage
Output short-circuit duration
Input current
Operating free-air temperature range
Storage temperature range
Maximum junction temperature
Thermal resistance junction to ambient
Thermal resistance junction to case
HBM: human body model
MM: machine model
CDM: charged device model
SO-8
MiniSO-8
TSSOP8
DIP8
SO-8
MiniSO-8
TSSOP8
DIP8
Absolute maximum ratings
(2)
Parameter
(5)
CC
can cause excessive heating if V
(4)
(6)
(1)
(3)
(3)
-55 to +125 -40 to +105
LM158,A
5 mA in DC or 50 mA in AC (duty
CC
CC
. Destructive dissipation can result
cycle = 10%, T=1s)
voltage level (or to ground for a large
CC
> 15 V. The maximum output
th
-65 to +150
Absolute maximum ratings
+/-16 or 32
are typical values.
LM258,A
Infinite
150
125
190
120
300
200
1.5
32
32
85
40
39
37
41
LM358,A
0 to +70
°C/W
°C/W
Unit
mA
kV
°C
°C
°C
V
V
V
V
V
3/19