S-1323B27NB-N8MTFG Seiko Instruments, S-1323B27NB-N8MTFG Datasheet - Page 14

• Manufacturer Part Number: S-1323B27NB-N8MTFG
• Description: IC REG LDO 150MA 2.7V SC-82AB
• Manufacturer: Seiko Instruments

Specifications of S-1323B27NB-N8MTFG

• Regulator Topology: Positive Fixed
• Voltage - Output: 2.7V
• Voltage - Input: Up to 6.5V
• Voltage - Dropout (typical): 0.5V @ 150mA
• Number Of Regulators: 1
• Current - Output: 150mA (Min)
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: SC-70-4, SC-82-4, SOT-323-4, SOT-343
• Number Of Outputs: 1
• Polarity: Positive
• Input Voltage Max: 6.5 V
• Output Voltage: 2.7 V
• Output Type: Fixed
• Dropout Voltage (max): 0.65 V at 150 mA
• Output Current: 150 mA
• Line Regulation: 0.1 % / V
• Load Regulation: 40 mV
• Voltage Regulation Accuracy: 1 %
• Maximum Power Dissipation: 0.4 W
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Limit (min): -
• Lead Free Status / Rohs Status: Details

14
HIGH RIPPLE-REJECTION AND SMALL PACKAGE CMOS VOLTAGE REGULATOR
S-1323 Series
Precautions
• Wiring patterns for the VIN, VOUT and GND pins should be designed so that the impedance is low.
• Note that the output voltage may increase when a series regulator is used at low load current (1.0 mA or
• Generally a series regulator may cause oscillation, depending on the selection of external parts. The
• The voltage regulator may oscillate when the impedance of the power supply is high and the input
• The application conditions for the input voltage, output voltage, and load current should not exceed the
• Do not apply an electrostatic discharge to this IC that exceeds the performance ratings of the built-in
• In determining the output current, attention should be paid to the output current value specified in Table
• SII claims no responsibility for any disputes arising out of or in connection with any infringement by
When mounting an output capacitor between the VOUT and VSS pins (C
the input between VIN and VSS pins (C
short as possible.
less).
following conditions are recommended for this IC. However, be sure to perform sufficient evaluation
under the actual usage conditions for selection, including evaluation of temperature characteristics.
capacitor is small or an input capacitor is not connected.
package power dissipation.
electrostatic protection circuit.
5 in the electrical characteristics and footnote *5 of the table.
products including this IC of patents owned by a third party.
Input capacitor (C
Output capacitor (C
Equivalent series resistance (ESR): 10 Ω or less
IN
):
L
):
IN
Seiko Instruments Inc.
), the distance from the capacitors to these pins should be as
1.0 μF or more
1.0 μF or more
L
) and a capacitor for stabilizing
Rev.5.0
_00