SMD200-2 Tyco Electronics, SMD200-2 Datasheet - Page 30

• Manufacturer Part Number: SMD200-2
• Description: POLYSWITCH 2.00A HOLD SMD
• Manufacturer: Tyco Electronics
• Series: PolySwitch®r

Specifications of SMD200-2

• R Min/max: 0.050 ~ 0.125 Ohm
• Voltage - Max: 15V
• Time To Trip: 12s
• Current - Hold (ih) (max): 2A
• Current - Trip (it): 4A
• Current - Max: 40A
• Package / Case: 3425
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: SMD200; SMD200CT

4
Latest Information
• Please visit us at www.circuitprotection.com or contact your local representative for the latest information.
• The information in this data package contains some preliminary information. Raychem Circuit Protection, a
• Operation beyond the maximum ratings or improper use may result in device damage and possible electrical
• The devices are intended for protection against occasional overcurrent or overtemperature fault conditions
• Contamination of the PPTC material with certain silicon based oils or some aggressive solvents can adversely
• Device performance can be impacted negatively if devices are handled in a manner inconsistent with recommended
• Operation in circuits with a large inductance can generate a circuit voltage (L
216
division of Tyco Electronics, reserves the right to change any of the specifications without notice. In addition,
Tyco Electronics reserves the right to make changes—without notification to Buyer—to materials or processing
that do not affect compliance with any applicable specification.
arcing and flame.
and should not be used when repeated fault conditions or prolonged trip events are anticipated.
impact the performance of the devices.
electronic, thermal, and mechanical procedures for electronic components.
the PolySwitch resettable device.
PolySwitch Surface-mount Resettable Devices
WARNING:
Carrier tape
B
1
T
K
T
Cover tape
1
0
Cover tape
Figure S21. EIA Taped Component Dimensions
Center lines
of cavity
Figure S22. EIA Reel Dimensions
Embossed cavity
A
D
0
A
0
B
P
0
1
P
2
P
0
Embossment
di
/
dt
N (hub dia.)
) above the rated voltage of
W
W
1
2
(measured at hub)
F
(measured at hub)
E
E
1
2
W
Raychem Circuit Protection