ERJ-XGNJ472Y Panasonic - ECG, ERJ-XGNJ472Y Datasheet - Page 9

• Manufacturer Part Number: ERJ-XGNJ472Y
• Description: RESISTOR 4.7K OHM 1/32W 5% 01005
• Manufacturer: Panasonic - ECG
• Series: ERJr

Specifications of ERJ-XGNJ472Y

• Resistance (ohms): 4.7K
• Power (watts): 0.03W, 1/32W
• Composition: Thick Film
• Temperature Coefficient: ±200ppm/°C
• Tolerance: ±5%
• Size / Dimension: 0.016" L x 0.008" W (0.40mm x 0.20mm)
• Height: 0.005" (0.13mm)
• Lead Style: Surface Mount (SMD - SMT)
• Package / Case: 01005 (0402 Metric)
• Resistance In Ohms: 4.70K
• Case: 01005 (0402 metric)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Other names: ERJXGNJ472Y; P4.7KAWTR

Subject
Part No.
10. Storage Method
Chip Resistor
If the product is stored in the following environments and conditions, the performance and
solderability may be badly affected, avoid the storage in the following environments.
(1) Storage in places full of corrosive gases such as sea breeze, Cl
(2) Storage in places exposed to direct sunlight.
(3) Storage in places outside the temperature range of 5 deg.C to 35 deg.C and humidity
(4) Storage over a year after our delivery (This item also applies to the case where the storage
(7) Halogen type (Chlorine type, Bromine type, etc.) or other high-activity flux is not
(8) When soldering with soldering iron, ground a tip of the soldering iron never touch the body
(9) Avoid physical shock to the resistor and nipping of the resistor with hard tool (a pair of
(10) Avoid immersion of chip resistor in solvent for long time. Use solvent after the effect of
(11) This resistance may change with ESD.
range of 45 %RH to 85 %RH.
method specified in item (1) to (3) has been followed.).
may impair performance and/or reliability of resistor. Never exceed the rated power. When
the product shall be used under special condition, be sure to ask us in advance.
recommended as the residue may affect performance or reliability of resistors.
of the chip resistor with a tip of the soldering iron. When using a soldering iron with a tip
at high temperature, solder for a time as short as possible. (three seconds or less up to
350 deg.C)
pliers or tweezers) as it may damage protective film or the body of resistor and may affect
resistor’s performance.
immersion is confirmed.
In case of handling this product, please take care as follows.
Environment which static electricity cannot generate easily.
Wearing of an earth band and a conductive glove.
Connecting surface mounting system to the earth.
Installation of the electric conduction mat on a work table.
( Recommendation humidity: 40 - 60%)
PRODUCT SPECIFICATION FOR IMFORMATION
Panasonic Electronic Devices Co., Ltd.
ERJXGN
2
, H
2
S, NH
3
Spec. No.
, SO
151-SRJ-EX07A
2
11
, and NO
-
8
X
.