MD6030NSZ-0 Knowles Acoustics, MD6030NSZ-0 Datasheet - Page 2

• Manufacturer Part Number: MD6030NSZ-0
• Description: MIC CONDENSER ELECT NC -39+-4DB
• Manufacturer: Knowles Acoustics
• Type: Electret Condenserr

Specifications of MD6030NSZ-0

• Sensitivity: -39dB ±4dB
• Voltage - Rated: 3V
• Current: 500µA
• Size / Dimension: Circular - 6mm Dia x 2.7mm H
• S/n Ratio: 55dB
• Impedance: 2.2K Ohm
• Frequency: 300Hz ~ 6kHz
• Termination: Solder Pads
• Direction: Noise Cancelling
• Port Location: Top
• Transducer Function: Microphone
• Device Type: Microphone
• Directivity: Noise Cancelling
• External Diameter: 6mm
• Output Impedance: 2.2kohm
• Outer Diameter: 6mm
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Filter Type: -
• Other names: 423-1019; MD6030NSZ0

Polar Pattern:
Polar plot shows reponce of unit at 1000 Hz.
Environmental Specifications
Operating Temperatur -25°C to +55°C
Storage Temperature: -25°C to +60°C
Humidity:
Temperature Cycles:
Low Temperature:
High Temperature:
ESD:
Vibration:
Impact:
Solder Pull:
EMKAY
EMKAY
EMKAY Innovative Products
A Knowles Electronics LLC
The information contained in this literature is based on our experience to date and is believed to be reliable and subject to change without
notice. It is intended as a guide for use by persons having technical skill at their own discretion and risk. We do not guarantee favorable
results or assume any liability in connection with its use. Dimensions contained herein are for reference purposes only. For specific
dimensional requirements consult the factory. This publication is not to be taken as a license to operate under, or a recommendation to
infringe any existing patents. This supersedes and voids all previous literature, etc.
Note: After any of the following tests performed, the sensitivity of the microphone unit shall not deviate
more than ±3dB from its initial value. The microphone shall maintain its initial operation and
appearance.
1151 Maplewood Drive, Itasca, Illinois 60143
Tel: [phone] Fax: [phone]
+40°C at 95%RH for 240 hrs
After exposure at -25°C for 30 minutes, at+20°C for 10 minutes, at +60°C
for 30 minutes, at +20°C for 10 minutes, 5 cycles. (The measurement to
be done after 2 hrs of conditioning at +20°C.)
The microphone unit must operate within its sensitivity specifications after
subjected to the following conditions: -25°C for 240 hrs, and exposed to
room temperature for 2 hrs.
The microphone unit must operate within its sensitivity specifications after
subjected to the following conditions: +60°C for 240 hrs, and exposed to
room temperature for 2 hrs.
10kV
The microphone to have no interference in operation after vibrations, 10Hz
to 55Hz for 1 minute full amplitude 1.52mm, for 2 hours at three axises.
The microphone unit must operate when dropped three times once on
each axis from a height of 1m onto a metal plate.
0.5kg each Pad
PRODUCT SPECIFICATION
Doc:
MD6030NSZ-0
www.emkayproducts.com