FMP300FRF73-1K Yageo, FMP300FRF73-1K Datasheet - Page 6

• Manufacturer Part Number: FMP300FRF73-1K
• Description: RES MET FILM 1K OHM 3W 1% AX
• Manufacturer: Yageo
• Series: FMPr

Specifications of FMP300FRF73-1K

• Resistance (ohms): 1K
• Power (watts): 3W
• Composition: Metal Film
• Features: Flame Proof
• Temperature Coefficient: ±100ppm/°C
• Tolerance: ±1%
• Size / Dimension: 0.197" Dia x 0.610" L (5.00mm x 15.50mm)
• Lead Style: Through Hole
• Package / Case: Axial
• Resistance In Ohms: 1.00K
• Case: Axial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Height: -

8. ENVIRONMENTAL CHARACTERISTICS
(1) Short Time Over Load Test
(2) Dielectric Withstanding Voltage
(3) Temperature Coefficient Test
(4) Insulation Resistance
(5) Solderability
(6) Resistance to Solvent
(7) Terminal Strength
At 2.5 times of the rated voltage. ( If the voltage exceeds the maximum load voltage, the maximum load
voltage will be used as the rated voltage ) applied for 5 seconds, the resistor should be free from defects
after the resistor is released from load for about 30 minutes
Short Time Overload Voltage =
The change of the resistance value should be within ± 0.5 % + 0.05Ω
The resistor is placed on the metal V Block. Apply a Table I dielectric withstanding between the
terminals connected together with the block for about 60 seconds.
The resistor shall be able to withstand without breakdown or flashover.
Test of resistors above room temperature 100°C ± 2°C ( Testing Temperature 115°C to 130°C ) at the
constant temperature silicon plate for over 5 minutes. Then measure the resistance value.
The Temperature Coefficient is calculated by the following equation and its value should be within the
range of requested.
Apply test terminal on lead and resistor body.
The test resistance should be high than 1,000M ohm.
Immerse the specimen into the solder pot at 260 ± 5 °C for 5 ± 0.5 seconds.
At least 95% solder coverage on the termination.
The specimen into the appropriate solvent of IPA condition of ultrasonic machine for 1 minutes.
The specimen is no deterioration of coatings and color code.
Direct Load – Resistors shall be held by one terminal and the load shall be gradually applied in the
direction of the longitudinal axis of the resistor unit the applied load reacheds 5 pounds。
The load shall be held for 10 seconds. The load of weight shall be ≧ 2.5 kg ( 24.5N ).
Re
sistor
R ＝ Resistance value under the testing temperature
R
t
t
o
0
＝ Resistance value at the room temperature
＝ The testing temperature
＝ Room temperature
Temperatur
e
Coefficien
2
5 .
*
Power Rati
Page-6
t
=
R
R
−
ng
R
0
×
0
×
Resistance
t
−
1
t
0
×
10
Value
6