CEP-1108 CUI Inc, CEP-1108 Datasheet - Page 3

• Manufacturer Part Number: CEP-1108
• Description: BUZZER PIEZO 2.5KHZ EXT DRIVE
• Manufacturer: CUI Inc
• Series: CEPr
• Type: Piezo Transducer, External Driver

Specifications of CEP-1108

• Frequency: 2.5kHz
• Voltage - Rated: 10Vp-p
• Current Rating: 7mA
• Size / Dimension: Circular - 22mm Dia x 5mm H
• Mounting Type: Through Hole
• Sound Pressure Level: 80dB
• Operating Mode: Continuous
• Capacitance @ Frequency: 18000pF @ 120Hz
• Voltage Range: 50Vp-p (max)
• Termination: Solder Pins/Posts
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 102-1142; CEP1108; SEP-1108; SEP1108

Environment Test
Item
High temp. test
Low temp. test
Humidity test
Temp. cycle test
Mechanical Characteristics
Item
Solderability
Soldering Heat Resistance
Terminal Mechanical Strength
Vibration
Drop Test
Phone: [phone]
Fax: [phone]
Test Condition
After being placed in a chamber at +95°C for
240 hours.
After being placed in a chamber at -40°C for
240 hours.
After being placed in a chamber at +40°C and
90±5% relative humidity for 240 hours.
The part shall be subjected to 5 cycles. One
cycle will consist of:
Test Condition
Lead terminals are immersed in rosin for
5 seconds and then immersed in solder bath
of 270 ±5°C for 3 ±1 seconds.
Lead terminals are immersed up to 1.5mm from
buzzer’s body in solder bath of 300 ±5°C for
3 ±0.5 or 260 ±5°C for 10 ±1 seconds.
For 10 seconds, the force of 9.8N (1.0kg) is
applied to each terminal in axial direction.
The buzzer should be measured after applying
a vibration amplitude of 1.5 mm with 10 to
55 Hz band of vibration frequency to each of
the 3 perpendicular directions for 2 hours.
The part will be dropped from a height of
75 cm onto a 40 mm thick wooden board 3
times in 3 axes (X, Y, Z) for a total of 9 drops.
Part No: CEP-1108
Description: piezo audio transducer
www.cui.com
20050 SW 112th Ave.
Evaluation Standard
Evaluation Standard
90% min. of the lead terminals
will be wet with solder.
(Except the edge of the terminal)
No interference in operation.
No damage or cutting off.
The value of oscillation
frequency/current consumption
should be ±10% of the initial
measurements. The SPL should
be within ±10dB compared with
the initial measurement.
The buzzer will be measured after
being placed at +25°C for 4
hours. The value of the
oscillation frequency/current
consumption should be ±10%
compared to the initial
measurements. The SPL should
be within ±10dB compared to the
initial measurements.
Tualatin, OR 97062
Date: 4/16/2007
Unit: mm
Page No: 3 of 5