X2-Z11-E-A Digi International, X2-Z11-E-A Datasheet - Page 240

• Manufacturer Part Number: X2-Z11-E-A
• Description: CONNECTPORT X2 2.4GHZ
• Manufacturer: Digi International
• Series: ConnectPort™ X2r

Specifications of X2-Z11-E-A

• Function: Transceiver, Xbee, Gateway
• Modulation Or Protocol: UDP/TCP, DHCP, SNMPv1
• Frequency: 2.4GHz
• Applications: General Purpose
• Interface: RJ-45
• Sensitivity: -82dBm
• Power - Output: 16dBm
• Data Rate - Maximum: 11Mbps
• Voltage - Supply: 12VDC
• Wireless Frequency: 2.4 GHz
• Interface Type: Ethernet
• Modulation: DBPSK, DQPSK
• Security: SSL Tunnel
• Operating Voltage: 9 V to 30 V
• Output Power: 1.2 W
• Antenna: 4 in Dipole
• Operating Temperature Range: - 30 C to + 70 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1173

Power LED
Status LED
Cellular Link LED
Cellular Activity
LEDs
Cellular Signal
Strength LEDs
XBee Link LED
LED/button
Green
Not illuminated
Yellow
1-1-1 blinking
yellow
1-5-1 blinking
yellow
Other blinking
yellow
Solid yellow
Blinking green
Blue
Green
Solid green
Fast blinking (20 Hz)
green
Slow (1 Hz) blinking
green
Off
Light Pattern
Color and
ConnectPort X4 and ConnectPort X4 H LEDs and buttons
Power is applied.
No power.
Blinks during product initialization and factory reset, using the light patterns below.
During normal device operation after initialization and factory reset, this LED is off and
should never blink. If it blinks constantly, contact Digi Technical Support.
Firmware is initializing.
Device configuration has been restored to its factory defaults.
Contact Digi Technical Support.
Cellular link is up.
Cellular traffic is on the link.
Relative signal strength indicator (RSSI), shown as a number of LEDs.
 
 
 
Specific dB values for the signal can be found via the web interface; go to
Administration > System Information > Mobile . Under Mobile Connection, the
signal strength is displayed in bars and dBm. Or, from the command line. enter the
display mobile command.
Indicates that the XBee RF module in the gateway has associated with an XBee
network:
For more information on this indicator, see the description of the D5 (DIO5
Configuration) parameter in the product manual for the XBee module.
XBee module in gateway is associated (or coordinator is started).
An Ident (identify) button has been pressed on a remote node.
XBee module in gateway is not associated.
XBee module in gateway is disabled or not recognized.
0: signal strength unknown or unacceptable
1: signal strength low/weak
5: signal strength high/excellent
Description
T r o u b l e s h o o t i n g
2 4 0