X2-Z11-E-A Digi International, X2-Z11-E-A Datasheet - Page 68

• Manufacturer Part Number: X2-Z11-E-A
• Description: CONNECTPORT X2 2.4GHZ
• Manufacturer: Digi International
• Series: ConnectPort™ X2r

Specifications of X2-Z11-E-A

• Function: Transceiver, Xbee, Gateway
• Modulation Or Protocol: UDP/TCP, DHCP, SNMPv1
• Frequency: 2.4GHz
• Applications: General Purpose
• Interface: RJ-45
• Sensitivity: -82dBm
• Power - Output: 16dBm
• Data Rate - Maximum: 11Mbps
• Voltage - Supply: 12VDC
• Wireless Frequency: 2.4 GHz
• Interface Type: Ethernet
• Modulation: DBPSK, DQPSK
• Security: SSL Tunnel
• Operating Voltage: 9 V to 30 V
• Output Power: 1.2 W
• Antenna: 4 in Dipole
• Operating Temperature Range: - 30 C to + 70 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1173

WiFi security settings
The WiFi security settings specify the wireless security settings that the wireless network uses.
Multiple security and authentication modes may be chosen depending on the configuration of the
access point or wireless network. The wireless device will automatically select and determine the
authentication and encryption methods to use while associating to the wireless network. If the
wireless network does not use security and uses an Open Network architecture, these settings do
not need to be modified.
Note that WPA settings require that the device communicate to Access Points and is not valid
when the Connection Method is set to Connect to wireless systems using peer-to-peer
(ad-hoc). Also, WPA pre-shared key (WPA-PSK) security is only valid when a specific
Network Name or SSID is being used.

Network Authentication: The authentication method or methods used for wireless
communications.
–
–
connection.
connection. At least one WEP key must be specified in order to use shared key
authentication.
establish a connection with an authentication server or access point. Wired
Equivalent Privacy (WEP) keys are dynamically generated to encrypt data over the
wireless network.
protocol is used with a pre-shared key (PSK). The PSK is calculated using a
passphrase and the network SSID.
authentication (EAP) is used to establish a connection with an authentication server
or access point. Encryption keys are dynamically generated to encrypt data over the
wireless link.
establish a a connection with an authentication server or access point. Wired
Equivalent Privacy (WEP) keys are dynamically generated to encrypt data over the
wireless link. A user name and password must be specified to use LEAP.
Use any available authentication method: Enables
actual method used will be determined by the capabilities of the wireless network.
Use the following selected method(s): Selects one or more authentication
methods for wireless communications.
Open System: IEEE 802.11 open system authentication is used to establish a
Shared Key: IEEE 802.11 shared key authentication is used to establish a
WEP with 802.1x authentication: IEEE 802.1x authentication (EAP) is used to
WPA with pre-shared key (WPA-PSK): The Wi-Fi Protected Access (WPA)
WPA with 802.1x authentication: The WPA protocol and IEEE 802.1x
Cisco LEAP: Lightweight Extensible Authentication Protocol (LEAP) is used to
C o n f i g u r e D i g i d e v i c e s
all of the methods. The
6 8