X4-A11-W-A Digi International, X4-A11-W-A Datasheet - Page 45

• Manufacturer Part Number: X4-A11-W-A
• Description: PORT XBEE 802.15.4 - WIFI802.11G
• Manufacturer: Digi International
• Series: ConnectPort™ X4r

Specifications of X4-A11-W-A

• Function: Transceiver, Xbee, Gateway
• Modulation Or Protocol: 802.15.4 Zigbee
• Frequency: 2.4GHz
• Interface: 1 USB, 1 RS-232, 1 RJ-45
• Sensitivity: -93dBm
• Power - Output: 15dBm
• Data Rate - Maximum: 54Mbps
• Voltage - Supply: 6 V ~ 30 V
• Wireless Frequency: 2.4 GHz
• Interface Type: RS-232, Ethernet, SMA
• Security: NAT, DES, 3DES, 256 bit AES
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Applications: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: NS9360
• Other names: 602-1109

Power cable fitting
Class 1, Div 2 units
Warning
For customers who have purchased a C1D2-approved unit with cable and conduit to wire into the
main power supply:
1
2
Non-Class 1, Div 2 units
For customers who have purchased a non-C1D2 approved unit with a standard power cord with a
plug on the end:
The unit can be plugged into a standard matching wall outlet that has an output between 100VAC
to 240VAC, 50Hz to 60Hz, and capable of supplying at least 24 Watts.
There are three power-cord options available: U.S.A 120V, European 240V, and U.K. 240V.
Make sure that the mains power to the junction box where the cable is to be wired into is off.
Wire the exposed end of the cable into the junction box using approved C1D2 wiring
regulations per National Electrical Code Article 501 (if located in the United States) and
other regulations applicable to the locality where it is installed.
See the Power cable wiring table below for information on wiring this cable to the
junction box. The mains voltage for this unit needs to be between 100VAC and
240VAC, 50Hz to 60 Hz, and be able to supply a minimum of 24 Watts.
The blue reset button inside the unit can be used to disconnect/reconnect power for units
that are hard-wired to power.
Do not plug in or apply power to the unit until all connections are made to the
unit in the following steps.
Frame Ground (FG)
Neutral (N)
Line (L)
Function
Green
White
Black
Cable Wire Color
Power cable wiring
1
2
3
Connector Pin
Power Supply
Phoenix
Number
H a r d w a r e i n s t a l l a t i o n
4 5