X4-A11-W-A Digi International, X4-A11-W-A Datasheet - Page 49

• Manufacturer Part Number: X4-A11-W-A
• Description: PORT XBEE 802.15.4 - WIFI802.11G
• Manufacturer: Digi International
• Series: ConnectPort™ X4r

Specifications of X4-A11-W-A

• Function: Transceiver, Xbee, Gateway
• Modulation Or Protocol: 802.15.4 Zigbee
• Frequency: 2.4GHz
• Interface: 1 USB, 1 RS-232, 1 RJ-45
• Sensitivity: -93dBm
• Power - Output: 15dBm
• Data Rate - Maximum: 54Mbps
• Voltage - Supply: 6 V ~ 30 V
• Wireless Frequency: 2.4 GHz
• Interface Type: RS-232, Ethernet, SMA
• Security: NAT, DES, 3DES, 256 bit AES
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Applications: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: NS9360
• Other names: 602-1109

Configure an IP address from the command-line interface
IP addresses and the iDigi Platform
Test the IP address configuration
The set network command configures an IP address from the command line. Include the following
parameters:





For example:
From the iDigi Platform interface the Ethernet/LAN address for a Digi device can be changed
only; an address cannot be assigned. The mobile/cellular device is typically provided by the
mobile service provider; check with your mobile service provider on how they handle addresses.
To change the IP address, open the web interface for based on the IP address the device has and
navigate to Configuration > Network > IP Settings. On the IP Settings page, enter the new IP
address, subnet mask, and gateway.
Once the IP address is assigned, make sure it works as configured.
1
2
ip=device ip: The IP address for the device.
gateway=gateway: The network gateway IP address.
submask=device submask: The device subnet mask.
dhcp=off: Turns off use of the Dynamic Host Configuration Protocol (DHCP), so that
the IP address assigned is permanent.
static=on: Specifies that the IP address is static, and will remain as the specified IP
address, gateway, and submask.
Access the command line of a PC or other networked device.
Issue the following command:
where ip-address is the IP address assigned to the Digi device. For example:
set network ip=10.0.0.100 gateway=10.0.0.1
submask=255.255.255.0 dhcp=off static=on
ping ip-address
ping 192.168.2.2
C o n f i g u r e D i g i d e v i c e s
4 9