X8-A11-E-A Digi International, X8-A11-E-A Datasheet - Page 174

• Manufacturer Part Number: X8-A11-E-A
• Description: CONNECTPORT X8 2.4GHZ
• Manufacturer: Digi International
• Series: ConnectPort™ X8r

Specifications of X8-A11-E-A

• Function: Transceiver, Xbee, Gateway
• Modulation Or Protocol: UDP/TCP, DHCP, SNMPv1
• Frequency: 2.4GHz
• Applications: General Purpose
• Interface: RJ45, DB-9, 2 USB
• Sensitivity: -93dBm
• Power - Output: 15dBm
• Data Rate - Maximum: 54Mbps
• Voltage - Supply: 12VDC
• Wireless Frequency: 2.4 GHz
• Interface Type: RS-232, Ethernet, USB
• Modulation: BPSK, CCK, DBPSK, DQPSK, QPSK
• Security: 256 bit AES, 3DES, DES, SSL Tunnel
• Operating Voltage: 9 V to 30 V
• Output Power: 3.1 W
• Antenna: 4 in Dipole with 2 ft Cable
• Operating Temperature Range: - 30 C to + 60 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1171

RealPort configuration settings
Applications > Realport displays a page for configuring the RealPort application. Settings on this
page include:


RealPort Settings
–
–
Device Initiated RealPort Settings:
–
–
–
–
in situations where traffic is measured for billing purposes.
Enable Keep-Alives: Enables sending of RealPort keep-alives. These keep-alives are
messages inside the RealPort protocol, sent approximately every 10 seconds, to tell
whoever is connected that the connection is still alive. RealPort keep-alives are different
from TCP keep-alives, which are done at the TCP layer.
Note that RealPort keep-alives generate additional traffic which may be undesirable
Enable Exclusive Mode: Exclusive mode allows a single connection from any one
RealPort client ID to be connected only. If this setting is enabled and a subsequent
connection occurs that has the same source IP as an existing connection, the old existing
connection is forcibly reset under the assumption that it is stale.
Index: An empty list means that no device initiated RealPort connections have been
configured
Host or IP Address: The IP address or DNS name of the client to connect to.
Port: The network port to connect to on the client. The default port for VNC servers is
8771.
Retry Time: The amount of time in seconds to wait before reattempting a failed
connection to the client.
C o n f i g u r e D i g i d e v i c e s
1 7 4