X8-A11-E-A Digi International, X8-A11-E-A Datasheet - Page 237

• Manufacturer Part Number: X8-A11-E-A
• Description: CONNECTPORT X8 2.4GHZ
• Manufacturer: Digi International
• Series: ConnectPort™ X8r

Specifications of X8-A11-E-A

• Function: Transceiver, Xbee, Gateway
• Modulation Or Protocol: UDP/TCP, DHCP, SNMPv1
• Frequency: 2.4GHz
• Applications: General Purpose
• Interface: RJ45, DB-9, 2 USB
• Sensitivity: -93dBm
• Power - Output: 15dBm
• Data Rate - Maximum: 54Mbps
• Voltage - Supply: 12VDC
• Wireless Frequency: 2.4 GHz
• Interface Type: RS-232, Ethernet, USB
• Modulation: BPSK, CCK, DBPSK, DQPSK, QPSK
• Security: 256 bit AES, 3DES, DES, SSL Tunnel
• Operating Voltage: 9 V to 30 V
• Output Power: 3.1 W
• Antenna: 4 in Dipole with 2 ft Cable
• Operating Temperature Range: - 30 C to + 60 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1171

XBee Network
Activity LEDs
Cellular Signal
Strength LEDs
Ethernet Link LED
Ethernet Activity
LED
Reset button
LED/button
Yellow (top LED)
Green (middle)
Red (bottom)
Solid red
Blinking red
Solid yellow
Blinking green
Light Pattern
Color and
ConnectPort X2 LEDs and buttons
Indicate network communications activity for the XBee RF module in the gateway:
For more information on this indicator, see the description of the D5
(DIO5 Configuration) parameter in the product manual for the RF module.
Serial Data Out (to host)
Serial Data In (from host)
Associate/Power Indicator. Indicates both power to the interface board and the network
association status for the RF module in the interface board.
RF module powered and not associated to a ZigBee network.
RF module has associated to a ZigBee network.
Relative signal strength indicator (RSSI), shown as a number of LEDs.
 
 
 
Specific dB values for the signal can be found via the web interface; go to
Administration > System Information > Mobile . Under Mobile Connection, the
signal strength is displayed in bars and dBm. Or, from the command line. enter the
display mobile command.
Ethernet link is up.
Ethernet traffic is on the link.
Single press : Performs equivalent of a power-cycle.
Press and hold : Resets device configuration settings to factory defaults (factory reset).
0: signal strength unknown or unacceptable
1: signal strength low/weak
3: signal strength high/excellent
Description
T r o u b l e s h o o t i n g
2 3 7