XT09-PKI-E Digi International/Maxstream, XT09-PKI-E Datasheet - Page 20

• Manufacturer Part Number: XT09-PKI-E
• Description: MODEM RF 900MHZ 1W ETHER
• Manufacturer: Digi International/Maxstream
• Series: XTend™r

Specifications of XT09-PKI-E

• Function: Transceiver, Modem
• Modulation Or Protocol: FHSS, FSK
• Frequency: 900MHz
• Interface: RJ-45 Ethernet
• Sensitivity: -110dBm
• Data Rate - Maximum: 10 kbps
• Voltage - Supply: 7 V ~ 28 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Power - Output: -
• Applications: -

9XTend‐PKG‐E™ Ethernet RF Modem – Product Manual v2.x4x [2007.01.04]
4. RF Modem Configuration
4.1. Programming Examples
4.1.1. Configuration Setup Options
Option #1 - Local Network Connection
Option #2 - Direct PC Connection
Refer to the ‘Command Mode’ section [p18] for information
regarding entrance into Command Mode, sending AT com-
mands and exiting Command Mode.
After installing the X-CTU and Com Port Redirector Software
[p8] to a PC, use one of the connection options below to send
commands to the XTend-PKG-E Ethernet RF Modem.
Connect a PC and the Ethernet RF Modem to active Ethernet connections of the same local net-
work [as shown in the figure below].
Figure 4‐01. Local Network Connection
Connect the Ethernet RF Modem directly to the PC through the PC's Ethernet port [as shown in the
figure below].
Figure 4‐02. Direct PC Connection
Configuration Setup:
1.
2.
3.
4.
5.
[Example is continued on the following page.]
© 2007 MaxStream, Inc., Confidential & Proprietary ‐ All Rights Reserved
Install both the X-CTU Software and the Ethernet Com Port Redirector [See 'Install Soft-
ware' [p8] section for more information].
Connect the Ethernet RF Modem to a PC using either a Local Network [Figure 4-01] or a
Direct PC [Figure 4-02] connection.
Follow the steps outlined in the 'Ethernet RF Modem Discovery' section [p9] to identify the
com port that will be used to configure the RF modem.
Launch the X-CTU Software on the PC and select the PC Settings tab.
Make sure values shown in the fields of the 'Com Port Setup' section match those of the
Ethernet RF Modem.
modem. Other programs such as
use of MaxStreamʹs X‐CTU Soft‐
Telnet Software can also be used
Examples in this section cite the
ware for programming the RF
to program the modem.
20