XT09-PKI-E Digi International/Maxstream, XT09-PKI-E Datasheet - Page 26

• Manufacturer Part Number: XT09-PKI-E
• Description: MODEM RF 900MHZ 1W ETHER
• Manufacturer: Digi International/Maxstream
• Series: XTend™r

Specifications of XT09-PKI-E

• Function: Transceiver, Modem
• Modulation Or Protocol: FHSS, FSK
• Frequency: 900MHz
• Interface: RJ-45 Ethernet
• Sensitivity: -110dBm
• Data Rate - Maximum: 10 kbps
• Voltage - Supply: 7 V ~ 28 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Power - Output: -
• Applications: -

9XTend‐PKG‐E™ Ethernet RF Modem – Product Manual v2.x4x [2007.01.04]
BT (Guard Time Before) Command
CC (Command Sequence Character) Command
CD (GPO2 Configuration) Command
CF (Number Base) Command
<AT Command Mode Options> The CC command
is used to set/read the ASCII character used
between guard times of the AT Command Mode
Sequence (BT + CC + AT). This sequence enters
the modem into AT Command Mode so that data
entering the modem (from the host) is recognized
as commands instead of payload.
<AT Command Mode Options> The CC command
is used to set/read the ASCII character used
between guard times of the AT Command Mode
Sequence (BT + CC + AT). This sequence enters
the modem into AT Command Mode so that data
entering the modem (from the host) is recognized
as commands instead of payload.
<Serial Interfacing> CD Command is used to
select/read the behavior of the GPO2 line (pin 3).
<Command Mode Options> CF command is used
to set/read the command formatting setting.
The following commands are always entered and
read in hex, no matter the CF setting:
© 2007 MaxStream, Inc., Confidential & Proprietary ‐ All Rights Reserved
VR (Firmware Version)
HV (Hardware Version)
KY (AES Encryption Key)
AT Command: ATCF
Parameter Range: 0 – 2
Default Parameter Value: 1
Number of bytes returned: 1
AT Command: ATCC
Binary Command: 0x13 (19 decimal)
Parameter Range: 0x20 - 0x7F
Default Parameter Value: 0x2B (ASCII “+”)
Number of bytes returned: 1
Related Commands: AT (Guard Time After), BT
(Guard Time Before)
AT Command: ATCC
Binary Command: 0x13 (19 decimal)
Parameter Range: 0x20 - 0x7F
Default Parameter Value: 0x2B (ASCII “+”)
Number of bytes returned: 1
Related Commands: AT (Guard Time After), BT
(Guard Time Before)
AT Command: ATCD
Binary Command: 0x28 (40 decimal)
Parameter Range: 0 - 8 (standard rates)
Default Parameter Value: 2
Number of bytes returned: 1
Parameter
Parameter
0
1
2
0
1
2
3
4
commands may output units
Commands utilize default
default number base; no
All commands forced to
unsigned, unit-less hex
Commands utilize their
number base; decimal
units are output
Configuration
(valid address only)
Configuration
Default High
Default Low
(reserved)
RX LED
RX LED
26