TDA5230 Infineon Technologies, TDA5230 Datasheet - Page 22

• Manufacturer Part Number: TDA5230
• Description: IC RECEIVER ASK/FSK 28-TSSOP
• Manufacturer: Infineon Technologies
• Type: Receiverr

Specifications of TDA5230

• Package / Case: 28-TSSOP
• Frequency: 433MHz ~ 450MHz, 865MHz ~ 868MHz
• Sensitivity: -111dBm
• Data Rate - Maximum: 20 kbps
• Modulation Or Protocol: ASK, FSK
• Applications: RKE, TPM, Security Systems
• Current - Receiving: 8mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 3 V ~ 3.6 V, 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 105°C
• Operating Frequency: 870 MHz
• Operating Supply Voltage: 3.3 V, 5 V
• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Memory Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: SP000076520; TDA5230; TDA5230INTR

2.4.1
The chip may be operated within a 5 V or a 3.3 V environment.
Figure 10
For operation within a 5 V environment, the chip is supplied via the pin VDD5V. In this
configuration a 5 to 3.3 V voltage regulator supplies the analog/RF-section (only active
in Run Modes) and a second 5 to 3.3 V voltage regulator supplies the digital I/O-pads.
When operating within a 3.3 V environment, the pins VDD5V, VDDA and VDDD must be
supplied. The 5 to 3.3 V voltage regulators are inactive in this configuration.
The internal digital core is supplied by an additional 3.3 to 1.5 V regulator.
The regulators for the digital section are controlled by the signal at the P_ON (Power
On). A low signal at P_ON disables all regulators and sets the IC into Power Down Mode.
A low to high transition at P_ON enables the regulators for the digital section and initiates
a power on reset. The regulator for the analog section is controlled by the Master Control
Unit and is active only when the RF-section is active (RX-RUN = high).
P_ON can be used to initiate a reset. The required negative pulse time t
in
Data Sheet
GNDRF
Chapter 4
GNDA
VDDA
P_ON
Power Supply
Specifications.
Power Supply
Section
Analog
Voltage Regulator
5 → 3.3 V
OUT
IN
Section
RF
RX-RUN
18
Power-Up
Brownout
Detector
Voltage Regulator
Voltage Regulator
3.3 → 1.5 V
5 → 3.3 V
OUT
OUT
IN
IN
Reset-
Circuit
Internal
Reset
Functional Description
Digital-Core
Version 4.0, 2007-06-01
Digital-I/O
P_ON
is specified
TDA523x
VDD5V
VDDD
VDDD1V5
GNDD