TMEB8704 Atmel, TMEB8704 Datasheet - Page 19

• Manufacturer Part Number: TMEB8704
• Description: KIT DEMO FOR RFID TRANSPONDERS
• Manufacturer: Atmel
• Type: Development kitr

Specifications of TMEB8704

• Contents: Board, Cables, Manual and more
• For Use With/related Products: e5530, T5552, T5557, TK5530, TK5551, TK5552, U2270B
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5.6
4781A–RFID–10/05
TK5561 Read/Write/Crypto Transponder
kit. In a real-time analysis, the incoming data stream is decoded to binary values and then sent
to the PC. Choosing the button Default restores the default setting. Clicking the Reset Transpon-
der button sends the reset command to the transponder. (There is no change in the
configuration or data blocks of the transponder.) To leave the TK5552 user interface, click the
Cancel button. Clicking the Direct Access... button makes blockwise reading possible. Make
sure that the right Header for the chosen block is typed into the header text field.
Figure 5-11. TK5552 Write Tab
When changing to the Write tab, the Write Setup and Write Timing are shown. With the buttons
Block 1 to 7, Block 8 to 15, Block 16 to 23 and Block 24 to 31, all 31 data blocks can be shown
by packages, each with 7 blocks. The first byte in Block 1, the header byte, is adjusted in the
header text field of the Read tab.
Use Write Timing to set the timing parameters for writing. Under normal operating conditions,
the default values can be used.
The programming of the transponder is performed by clicking Program Transponder. The data
for each block is entered using hexadecimal code (characters 0 to 9 and A to F). The blocks to
be programmed are selected by selecting the box in the Write column. To protect the data from
being overwritten, the Lock bit feature can be used. Once set, the information cannot be over-
written anymore. (Please use this feature with care.) Selecting the button Default restores the
default setting. Clicking the Reset Transponder button sends the reset command to the tran-
sponder. (There is no change in the configuration or data blocks of the transponder.) To leave
the TK5552 user interface, click on the Cancel button.
When the transponder TK5561 is selected, the Read tab of the TK5561 user interface is shown.
This sheet enables to set the following parameters in the Configuration Setup (on the left side):
• Bit rate: Rf/32 and Rf/64
TMEB8704 Application Note
19