IRAMS10UP60B International Rectifier, IRAMS10UP60B Datasheet - Page 9

• Manufacturer Part Number: IRAMS10UP60B
• Description: PLUG N DRIVE INTELLIGENT PWR MOD
• Manufacturer: International Rectifier
• Series: iMOTION™r
• Type: IGBTr

Specifications of IRAMS10UP60B

• Configuration: 3 Phase
• Current: 10A
• Voltage: 600V
• Voltage - Isolation: 2000Vrms
• Package / Case: PCB Module
• Current, Input Bias: 200 μA
• Current, Quiescent Supply: 165 μA
• Current, Rms Phase: 10 A
• Frequency: 20 KHz
• Number Of Pins: 25
• Power Dissipation: 2.2 W
• Switching Loss: 275 μJ
• Temperature, Junction, Maximum: 150 °C
• Voltage, Breakdown, Collector To Emitter: 600 V
• Voltage, Input: 20 + 0.3 V
• Voltage, Input, High Level: 3 V
• Voltage, Input, Low Level: 0.8 V
• Voltage, Supply: 20 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: *IRAMS10UP60B

1. Electrolytic bus capacitors should be mounted as close to the module bus terminals as possible to reduce ringing and
EMI problems. Additional high frequency ceramic capacitor mounted close to the module pins will further improve perfor-
mance.
2. In order to provide good decoupling between V
tween these terminals should be located very close to the module pins. Additional high frequency capacitors, typically
0.1µF, are strongly recommended.
3. Value of the boot-strap capacitors depends upon the switching frequency. Their selection should be made based on
IR design tip DN 98-2a, application note AN-1044 or Figure 9. Bootstrap capacitor value must be selected to limit the
power dissipation of the internal resistor in series with the V
4. Current sense signal can be obtained from pin 22 and pin 23. Care should be taken to avoid having inverter current
flowing through pin 22 to mantain required current measurement accuracy.
5. After approx. 8ms the FAULT is reset. (see Dynamic Characteristics Table on page 5).
6. PWM generator must be disabled within Fault duration to garantee shutdown of the system, overcurrent condition
must be cleared before resuming operation.
7. Fault/Enable pin must be pulled-up to +5V.
Typical Application Connection IRAMS10UP60B
www.irf.com
+5V
CONTROLLER
CAPACITORS
Fault
DC BUS
Monitor
PGND
Temp
47kohm
+5V
DGND
+15V
0.1mF
1K
DGND
+5V
3-Phase AC
10mF
MOTOR
CC
-V
SS
BOOT-STRAP
CAPACITORS
W
U
and V
V
CC
. (see maximum ratings Table on page 3).
B1,2,3
-V
S1,2,3
2.2µF
Fault/Enable
V
cc
HIN1
HIN2
HIN3
(15 V)
LIN1
LIN2
LIN3
I
terminals, the capacitors shown connected be-
V
TRIP
V
V
V
TH
SS
+
-
V
V
V
B3
B2
B1
IRAMS10UP60B
V
V
V
S3
S2
S1
9