192993-0073 ITT Cannon, 192993-0073 Datasheet - Page 76

• Manufacturer Part Number: 192993-0073
• Description: TRI TNM RECP M FLG SEAL 0-12
• Manufacturer: ITT Cannon

Specifications of 192993-0073

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: I192993-0073

Cannon Trident Connectors
Crimping Instructions —
Formed (Stamped) Crimp
Contacts
Assembly Instructions:
1. Strip wires to length. For wire strip lengths,
see page 67.
2. Open the hand tool and place the contact
in the chosen die, ensuring that the locating
plate is positioned between the collar and
crimp saddle. Then squeeze tool gently to
hold the contact in place.
3. Insert the wire.
4. Cycle the tool.
5. Remove the wire and inspect the crimp.
The strands should be visible at both ends of
the crimp. There should be no loose strands
(see Figures 1-3). The contact should be co-linear
with the wire (see Figure 4). Bent contacts
are unacceptable (see Figure 5).
Figure 4 - Correct
Crimping Instructions —
Machined Crimp Contacts
Assembly Instructions:
1. Strip wires to length. For wire strip
lengths, see page 69.
2. Attach the correct locator (turret) to
the hand tool.
3. Adjust the dial for the wire gauge.
4. Place the contact into the locator and
insert the wire into the contact as indicat-
ed on the locator (turret) label.
Contact Type
Earthing
Socket
Pin
Side View
Locator Color
Green
Black
Blue
Front View
5. Cycle the tool.
6. Remove and inspect the contact.
Strands should be visible through the
inspection window (see Figure 6). There
should be no loose strands (see Figure 7).
Figure 6 - Correct
Figure 1 - Correct
Figure 5 - Unacceptable
76
Side View
Specifications and dimensions subject to change
Figure 2 - Unacceptable
Figure 3 - Unacceptable
Figure 7 - Unacceptable
Assembly Instructions
1
2
3
4
Dimensions shown in mm (inch)
Notes:
Wire Insulation.
Wire Strands.
Contact.
Inspection Window.
Strands must be visible.
Front View
www.ittcannon.com