VNC2 DEBUG MODULE FTDI, VNC2 DEBUG MODULE Datasheet - Page 2

• Manufacturer Part Number: VNC2 DEBUG MODULE
• Description: Interface Modules & Development Tools USB Vinculum-II Debug/Programmer Mod
• Manufacturer: FTDI

Specifications of VNC2 DEBUG MODULE

• Interface Type: USB, Serial, UART, FIFO, SPI
• Data Bus Width: Serial, 8 bit
• Operating Supply Voltage: 5 V
• Product: Interface Development Tools
• Ic Product Type: Debugger / Programmer
• Kit Contents: Miniature Board, USB Connector
• Features: Low USB Bandwidth Consumption, Programming And Debugging For VNC2 IC Designs
• Svhc: No SVHC (18-Jun-2010)
• Rohs Compliant: Yes
• Supported Devices: VNC2
• For Use With/related Products: VNC2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Document Reference No.: FT_000254
VNC2 Debug Module Datasheet Version 1.0
Clearance No.: FTDI# 149
`
1
Introduction
The following data sheet details the features and specifications of the VNC2 debug module. The VNC2
debug module is designed to provide connectivity between the Vinculum-II IDE development software
and the debug interface pin on the FTDI Vinculum-II (VNC2) USB host controller device.
The VNC2 debug module consists of a miniature board with a USB miniB connector, which provides USB
connectivity to Vinculum-II IDE development tools running on a PC. The VNC2 debug module can be
used to program and debug firmware running on the VNC2 device.
The module connects to the VNC2 device via a 6-way, 2mm pitch, keyed, female connector. The V2DIPx-
x, VNC2 based development modules are equipped with a compatible male connector to host the VNC2
debug module. Designers intending to use the module with their own VNC2 based hardware are required
to have a similar compatible male connector on their hardware.
Details on the debug interface and
connectors are outlined in subsequent sections of this document.
Figure 1.1
VNC2 Debugger Module
Copyright © 2010 Future Technology Devices International Limited
1