FT2232H MINI MODULE FTDI, FT2232H MINI MODULE Datasheet - Page 12

• Manufacturer Part Number: FT2232H MINI MODULE
• Description: Interface Modules & Development Tools USB Hi-Speed FT2232H Evaluation Module
• Manufacturer: FTDI

Specifications of FT2232H MINI MODULE

• Interface Type: USB, Serial, UART, FIFO, I2C, JTAG, SPI
• Data Bus Width: Serial, 8 bit
• Operating Supply Voltage: 3.3 V, 5 V
• Product: Interface Modules
• For Use With/related Products: FT2232H
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: FT2232HQ_MINI_ MODULE

Appendix A – FT2232H EEPROM Configuration
The FT2232H Mini Module utilizes an EEPROM which contains the USB configuration descriptors for the
FT2232H. When the Mini Module is plugged into a PC or a USB reset is performed, the PC will read these
descriptors. The default values stored into the EEPROM are defined in Table 6.1.
Parameter
USB Vendor ID (VID)
USB Product UD (PID)
Serial Number Enabled?
Serial Number
Pull down I/O Pins in USB
Suspend
Manufacturer Name
Product Description
Max Bus Power Current
Power Source
Device Type
USB Version
Remote Wake Up
High Current I/Os
Load VCP Driver
Table 6.1 Default Internal EEPROM Configuration
The EEPROM on the FT2232H Mini Module can be re-programmed over USB using the utility program
MPROG. MPROG can be downloaded from the www.ftdichip.com. Version 3.5 or later is required for the
FT2232H chip. Users who do not have their own USB Vendor ID but who would like to use a unique
Product ID in their design can apply to FTDI for a free block of unique PIDs. Contact FTDI support for this
service.
Copyright © 2011 Future Technology Devices International Limited
`
Value
0403h
6010h
Yes
See Note
Disabled
FTDI
FT2232H_MM
500mA
Bus Powered
FT2232
0200
Enabled
Enabled
Disabled
FT2232H Mini Module USB Hi-Speed FT2232H Evaluation Module Datasheet
Notes
FTDI default VID (hex)
FTDI default PID (hex)
A unique serial number is generated and programmed into
the EEPROM during device final test.
Enabling this option will make the device pull down on the
UART interface lines when the power is shut off (PWREN#
is high).
Returns USB 2.0 device description to the host.
Note: The device is be a USB 2.0 Full Speed device
(12Mb/s) as opposed to a USB 2.0 High Speed device
(480Mb/s).
Taking RI# low will wake up the USB host controller from
suspend.
Enables the high drive level on the UART and CBUS I/O
pins.
Makes the device load the VCP driver interface for the
device.
Document Reference No.: FT_000114
Clearance No.: FTDI#72
Version 1.6
10