FLASHPRO LITE

Manufacturer Part NumberFLASHPRO LITE
DescriptionProgrammers & Debuggers ProAsic Plus Programmer
ManufacturerActel
FLASHPRO LITE datasheet
 


Specifications of FLASHPRO LITE

Positions/sockets1Lead Free Status / RoHS StatusLead free / RoHS Compliant
1
Page 1
2
Page 2
Page 1/2

Download datasheet (104Kb)Embed
Next
FlashPro Lite Device Programmer
Quickstart Card
This quickstart card applies only to the FlashPro Lite device programmer.
Kit Contents
Quantity
1
FlashPro Lite programmer standalone unit
1
Ribbon cable for FlashPro Lite
1
IEEE 1284 parallel port cable
Software Installation
If you are already using Actel's Libero® Integrated Design Environment (IDE), you have the
FlashPro software installed as part of Libero IDE. If you are using the FlashPro Lite device
programmer for standalone programming or on a dedicated machine, download and install the latest
release of the FlashPro software from the Actel website. The installation will guide you through the
setup. Complete the software installation before connecting the FlashPro Lite device programmer to
your PC. The installation will ask you “Will you be using FlashPro Lite or FlashPro programmer via
parallel port?”, answer “Yes”.
Software releases: www.actel.com/download/program_debug/flashpro.
Hardware Installation
1.
Connect the programmer to a parallel printer port on your PC. Connect one end of the IEEE
1284 cable to the programmer’s connector. Plug the other end of the cable into your parallel
printer port and tighten the screws. You should not have any licensing dongles connected
between the parallel port and cable. Your port settings must be EPP or bidirectional. Actel also
supports the ECP mode with the FlashPro v2.1 software and newer.
© 2009 Actel Corporation. All rights reserved.
Description

FLASHPRO LITE Summary of contents

  • Page 1

    ... FlashPro software from the Actel website. The installation will guide you through the setup. Complete the software installation before connecting the FlashPro Lite device programmer to your PC. The installation will ask you “Will you be using FlashPro Lite or FlashPro programmer via parallel port?”, answer “Yes”. ...

  • Page 2

    ... Connecting to a serial port or a third-party card can damage the programmer. This type of damage is not covered by the warranty. 3. Connect the FlashPro Lite ribbon cable to the programming header and turn the target board on. Common Issues If you see two blinking LEDs on the programmer after you have connected the programmer to the parallel port, make sure the parallel port cable is connected firmly to the PC parallel port. For more information, refer to the FlashPro Software and Hardware Installation Guide and the “ ...