FT232RL-REEL FTDI, FT232RL-REEL Datasheet - Page 33

• Manufacturer Part Number: FT232RL-REEL
• Description: USB Interface IC USB to Serial UART Enhanced IC SSOP-28
• Manufacturer: FTDI
• Type: USB to UARTr

Specifications of FT232RL-REEL

• Maximum Operating Temperature: 85 C
• Minimum Operating Temperature: -40 C
• Mounting Style: SMD/SMT
• Supply Current: 15 mA
• Operating Supply Voltage: 3.3 V to 5.25 V
• Package / Case: SSOP 5.3mm x 10.28mm
• Description/function: USB to Serial UART Enhanced IC SSOP-28
• Operating Temperature Range: - 40 C to + 85 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

8
Following a power-on reset or a USB reset the FT232R will scan its internal EEPROM and read the USB
configuration descriptors stored there. The default factory programmed values of the internal EEPROM
are shown in Table 8.1.
Pull down I/O Pins in USB
Serial Number Enabled?
Max Bus Power Current
USB Product UD (PID)
USB Vendor ID (VID)
Manufacturer Name
Product Description
Internal EEPROM Configuration
High Current I/Os
Remote Wake Up
Load VCP Driver
Serial Number
Power Source
USB Version
Device Type
Parameter
Suspend
CBUS0
CBUS1
CBUS2
CBUS3
Copyright © 2010 Future Technology Devices International Limited
FT232R USB UART
Bus Powered
See Note
PWREN#
Disabled
Disabled
RXLED#
TXLED#
Enabled
Enabled
FT232R
TXDEN
0403h
6001h
90mA
Value
0200
FTDI
Yes
FTDI default VID (hex)
FTDI default PID (hex)
A unique serial number is generated and
programmed into the EEPROM during device final
test.
Enabling this option will make the device pull down
on the UART interface lines when in USB suspend
mode (PWREN# is high).
Returns USB 2.0 device description to the host.
Note: The device is a USB 2.0 Full Speed device
(12Mb/s) as opposed to a USB 2.0 High Speed
device (480Mb/s).
Taking RI# low will wake up the USB host controller
from suspend in approximately 20 ms.
Enables the high drive level on the UART and CBUS
I/O pins.
Makes the device load the VCP driver interface for
the device.
Default configuration of CBUS0 – Transmit LED
drive.
Default configuration of CBUS1 – Receive LED drive.
Default configuration of CBUS2 – Transmit data
enable for RS485
Default configuration of CBUS3 – Power enable. Low
after USB enumeration, high during USB suspend
mode.
FT232R USB UART IC Datasheet Version 2.07
Document No.: FT_000053
Clearance No.: FTDI# 38
Notes
33