CPN688 Emerson Network Power, CPN688 Datasheet - Page 19

• Manufacturer Part Number: CPN688
• Description: CONN N STR CRIMP RG-8,213 COAX
• Manufacturer: Emerson Network Power
• Series: N Typer
• Type: Cable Plugr

Specifications of CPN688

• Connector Style: N Type
• Connector Type: Plug, Male Pins
• Contact Termination: Crimp and Solder
• Impedance: 50 Ohm
• Mounting Type: Free Hanging (In-Line)
• Fastening Type: Threaded
• Cable Group: RG-8, 213
• Frequency - Max: 11GHz
• Frequency-max: 11GHz
• Angle: Straight
• Application: Commercial
• Cable Type: RG-8
• Contact Plating: Gold
• Finish, Housing: Nickel
• Material, Contact: Brass, Beryllium Copper or Phosphor Bronze
• Material, Dielectric: TFE/Delrin
• Material, Housing: Brass
• Mating Type: Threaded
• Primary Type: N
• Termination: Crimp/Solder
• Voltage, Rating: 500 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Color: -
• Lead Free Status / Rohs Status: RoHS Compliant part
• Other names: 012446238190; 367-1079; CPN-68-8

Type N Bulkhead Jack Crimp Style for RG-316 and
316DS Flexible Cable
1. Identify connector parts (6 piece parts).
2. Strip cable to dimensions shown. Do not nick center
3. Assemble rear contact onto cable as shown. Rear contact
4. Flare braid and slide bulkhead jack connector assembly over
5. Arrange braid uniformly around crimp stem. Slide crimp
6. Add gasket, lock washer and mounting nut when installing
Cable Group
RG-316/U, 161, 174, 188
RG-316 DS, 188 DS
Tool
Crimp Frame
Die Set
Contact Tool
Positioner
conductor. A wire stripper of correct size is recommended
for this step. Tin center conductor if contact will be solder
attached. Do not tin center conductor if contact will be crimp
attached. Slide crimp sleeve onto jacket of cable.
should butt against cable dielectric during attachment.
Solder Attachment: Solder rear contact to center conductor
through solder hole using .020 (.051) diameter flux core solder
wire. Use a minimum amount of solder for a good joint.
Crimp Attachment: Crimp rear contact to center conductor
using Johnson indent hand tool 140-0000-970. Crimp location
should be centered between end of rear contact and solder
hole using positioning tool 140-0000-971. Crimp attachment to
solid center conductor cables is not recommended.
rear contact and under braid. Rear contact must engage fully
with internal captivated jack contact. Cable jacket should be
located near end of crimp stem when contacts are fully
engaged.
sleeve forward and crimp using Johnson ergonomic hand
crimp frame 140-0000-967 with recommended hex size die set.
Maintain forward pressure on cable while crimping.
connector to panel.
Connectivity....for
Business-Critical Continuity
Part No.
138-4303-407
138-4304-407
Assembly
138-4303/4304-407
140-0000-967
140-0000-990
140-0000-970
140-0000-971
Crimp Sleeve Hex Size
.128 (3.25)
.151 (3.84)
Contact Crimp
8 INDENT
8 INDENT
Type N Connectors
19