HPR3

Manufacturer Part NumberHPR3
DescriptionPWR SUPP 5000W 19"RACK 3U 4SLOTS
ManufacturerEmerson Network Power
SeriesHPS
HPR3 datasheet
 


Specifications of HPR3

Accessory TypeEnclosureFor Use With/related ProductsHPS 10/12/15 Series
1
Page 1
2
Page 2
3
Page 3
4
Page 4
5
Page 5
Page 1/5

Download datasheet (261Kb)Embed
Next
1000-6000 Watts
HPS10/12/15 Series
Special Features
• Integrated OR-ing diode
• Remote Sense on Bulk output
• Overload protection on all outputs
• Active Inrush limiting
• PFC to 0.99 typical EN61000-3-2
• CISPR22, EN55022 Curve B
conducted/radiated EMI
• EN61000 immunity standards
• Optional 48 W fan voltage (12 V or 24 V)
• Standard 5 V at 5 A standby voltage (3.3V option)
• No minimum load
• Overvoltage protection
• Input OK signal and indicator LED
• Inhibit/Enable
• Remote Margin/Voltage Programming
• Optional current monitor
• Optional AC Line discrimination
• Output Good signal and indicator LED
• Temp good signal and indicator LED
• Optional single wire digital temp monitor
2
• Optional module I
C interface
• Optional Rack µController
• Hot Plug
• N+1 Redundant Standard
• Optional fan fail signal
• Module present signal
• Optional short circut latch
Environmental & Safety
Operating temperature: -10°C to +50°C ambient,
derate output @ 2.5% per degree from 50°C to 70°C
Shock/Vibration: Mil-Hdbk 810E
Humidity: 95% non-condensing
Storage temperature: -40°C to +85°C
Temperature coefficient: 0.02% per °C
Cooling: Internal DC fan
MTBF (Calculated): 200 KHrs; 25°C, 200 VAC input,
nominal O/P voltage, full load
Safety:
UL / CSA UL60950 3
rd
Ed and CSA C22.2 60950
TUV
EN60950
CB
Certificate and report
CE
Mark
152
Technical Support: (888) 41-ASTEC or (407) 241-2752
Americas: (760) 930-4600
Electrical Specs
Input
Input voltage
Frequency
Inrush current
Efficiency
Power factor
Turn-on time
EMI filter standard
Leakage current standard
Radiated EMI
Holdup time
AC OK
Harmonic distortion
Isolation
* see modules table on the next page
Output
Margining
Overall reg
Ripple
Dynamic response
Recovery time
Overcurrent protection
Short circuit protection
Overvoltage protection
Reverse voltage
protection
Thermal protection
Remote sense
Single wire parallel
DC OK
Minimum load
Standby voltage
Global Inhibit/Enable
Europe (UK) 44 (1384) 842-211
Asia (HK) 852-2437-9662
85-264 VAC*
47-440 Hz
40 A peak max.
85% typ @ full case load 230 VAC
0.99 typical meets EN61000-3-2
AC on 1.5 sec. typical, Inhibit /
Enable 100 ms typical
CISPR 22 EN55022 Level “B”
2 mA max @ 264 VAC @ 60Hz
(per module)
CISPR 22 EN55022 Level “B”
20 ms minimum
(independent of input VAC)
>5 ms early warning min. before
outputs lose regulation; Full cycle
ride thru (50 Hz)
Meets EN61000-3-2
Meets EN60950
±5% of nominal
1%
1% of Vout Pk-Pk limited to 20 MHz
2% with 25% load step
To within 1% in <300 µsec
105-120% of rated output current
Protected for continuous short
circuit. Recovery is automatic upon
removal of short
105-120% . Recycle AC input voltage
to reset OVP circuit
100% of rated output current
Main and Aux disabled when internal
temp exceeds safe operating range.
Up to 0.5 V total drop
Current share to within 10% of total
rated current
±5% of nominal
Not required
5 VDC @5A max. present whenever
AC input is applied (3.3 V @ 5A
optional)
Logic “0” standard logic “1” optional
rev 08.25.04

HPR3 Summary of contents

  • Page 1

    Watts HPS10/12/15 Series Special Features • Integrated OR-ing diode • Remote Sense on Bulk output • Overload protection on all outputs • Active Inrush limiting • PFC to 0.99 typical EN61000-3-2 • CISPR22, EN55022 Curve B conducted/radiated EMI • ...

  • Page 2

    ... XXX HPR Standard Options options 01 = computer option HPR3 M M odule B B lank P P anel: Astec P/N 73-536-026 HPR3 L L ogic B B lank P P anel: Astec P/N 73-536-027 Notes: 1. Specifications subject to change without notice 2. All dimentions are in inches (mm), toleance is ± .02” ...

  • Page 3

    HPS Series DRAWINGS HPS 10/12/15 Module 154 Technical Support: (888) 41-ASTEC or (407) 241-2752 Americas: (760) 930-4600 A B Europe (UK) 44 (1384) 842-211 Input Connector Positronics PLB3W3M1060 AC Pin: MC612N-228.2 Ground Pin: MC612N ...

  • Page 4

    ... HPR3 Rack J20 J21 J22 www.astecpower.com EUROPE AMERICAS Astec House, Waterfront Business Park 5810 Van Allen Way Merry Hill, Dudley Carlsbad, CA 92008 West Midlands, DY5 1LX, UK Telephone: 760-930-4600 Telephone: 44 (1384) 842-211 Facsimile: 760-930-0698 Facsimile: 44 (1384) 843-355 ASIA Units 2111-2116, Level 21 Tower1, Metroplaza ...

  • Page 5

    ... HPR3 - ssignments J21 Control Connector for PS1 & PS2 (Slot 1 & 2) PS1 Pin No. Function J21-1 +V Anode ( module present ) J21 collector J21-3 I monitor return J21-4 Op amp / Sync / Fan Fail Signal J21-5 Enable / Inhibit (isolated) J21-6 Enable / Temp OK / Fan Fail RTN J21-7 Margin Program ...