S29GL256P10TFI010 Spansion Inc., S29GL256P10TFI010 Datasheet - Page 21

• Manufacturer Part Number: S29GL256P10TFI010
• Description: IC, FLASH, 256MBIT, 100NS, TSOP-56
• Manufacturer: Spansion Inc.

Specifications of S29GL256P10TFI010

• Memory Type: Flash
• Memory Size: 256Mbit
• Memory Configuration: 32M X 8 / 16M X 16
• Ic Interface Type: CFI, Parallel
• Access Time: 100ns
• Supply Voltage Range: 2.7 To 3.6 V
• Memory Case Style: TSOP
• Data Bus Width: 8 bit, 16 bit
• Architecture: Uniform
• Interface Type: Page-mode
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.7 V
• Maximum Operating Current: 50 mA
• Mounting Style: SMD/SMT
• Operating Temperature: + 85 C
• Package / Case: TSOP-56
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

7.6
November 8, 2007 S29GL-P_00_A7
Autoselect
The Autoselect mode provides manufacturer ID, Device identification, and sector protection information,
through identifier codes output from the internal register (separate from the memory array) on DQ7-DQ0. This
mode is primarily intended for programming equipment to automatically match a device to be programmed
with its corresponding programming algorithm (see
in-system.
There are two methods to access autoselect codes. One uses the autoselect command, the other applies V
on address pin A9.
When using programming equipment, the autoselect mode requires V
Address pins must be as shown in
To access Autoselect mode without using high voltage on A9, the host system must issue the Autoselect
command.
The Autoselect command sequence may be written to an address within a sector that is either in the read
or erase-suspend-read mode.
The Autoselect command may not be written while the device is actively programming or erasing.
The system must write the reset command to return to the read mode (or erase-suspend-read mode if the
sector was previously in Erase Suspend).
It is recommended that A9 apply V
that A9 apply from V
See
When verifying sector protection, the sector address must appear on the appropriate highest order address
bits (see
been set as required, the programming equipment may then read the corresponding identifier code on
DQ15-DQ0. The Autoselect codes can also be accessed in-system through the command register.
Table 12.1 on page 68
Table 7.4
D a t a
to
S h e e t
ID
Table
to V
S29GL-P MirrorBit
IH
for command sequence details.
7.5). The remaining address bits are don't care. When all necessary bits have
/V
IL
( P r e l i m i n a r y )
Table
before power-down the V
ID
after power-up sequence is completed. In addition, it is recommended
7.2.
®
Flash Family
Table
7.3). The Autoselect codes can also be accessed
CC
/V
IO
.
ID
(11.5 V to 12.5 V) on address pin A9.
21
ID