QS30LLPQ BANNER ENGINEERING, QS30LLPQ Datasheet - Page 3

• Manufacturer Part Number: QS30LLPQ
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of QS30LLPQ

• Sensing Range: 0.2m To 18m
• Output Current: 150mA
• Sensor Output: NPN/PNP
• Supply Voltage Range Dc: 10V To 30V
• Sensor Housing: Rectangular
• Sensing Range Min: 0.2m
• Sensor Input: Laser
• Body Material: ABS Plastic

WORLD-BEAM
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
•
Minneapolis, MN U.S.A.
®
QS30 Series –
Sensor configuration is accomplished using the SET and SETUP modes. After SET
mode has defined the sensing parameters, SETUP mode may be used to add an OFF-
delay or change the light/dark operate status. Manual Adjust may be used to fine-tune
the thresholds. Two push buttons, “+” and “-”, may be used to access and set sensing
parameters. In addition, the remote wire also may be used for some procedures (see
below).
The Remote Configuration function may be used to set the sensor threshold remotely
or to disable the push buttons for security. Connect the gray wire of the sensor to
ground (0V dc), with a remote programming switch connected between them. Pulse
the remote line according to the diagrams in the programming procedures. The length
of the individual programming pulses is equal to the value T:
In addition to its programming function, Remote Programming may be used to
disable the push buttons for security. Disabling the push buttons prevents undesired
tampering with the programming settings. Connect the gray wire of the sensor as
described on above, and four-pulse to either enable or disable the push buttons:
T
T
Polarized Retroreflective Laser Sensors
0.04 seconds ≤ T ≤ 0.8 seconds
Remote Configuration
Sensor Configuration
Push Button Disable
T T T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
P/N 112355 rev. A
3