S18UBAR BANNER ENGINEERING, S18UBAR Datasheet - Page 5

• Manufacturer Part Number: S18UBAR
• Description: Ultrasonic Sensor
• Manufacturer: BANNER ENGINEERING
• Type: Ultrasonicr

Specifications of S18UBAR

• Sensing Range Min: 30mm
• Sensing Range Max: 300mm
• Switching Frequency: 300kHz
• External Diameter: 18mm
• Operating Temperature Range: -20°C To +60°C
• Supply Voltage: 30VDC
• Frequency: 300kHz
• Brand/series: S18U
• Current, Switching: 100 mA
• Function: Proximity
• Ip Rating: IP67
• Mounting Type: Threaded
• Output: NPN/PNP, SPST
• Primary Type: Proximity
• Range, Measurement: 300 mm
• Technology: Ultrasonic
• Termination: 5-Wire Cable
• Voltage, Supply: 30 VDC
• Accessories Available: Cordsets, Brackets and Waveguides
• Body Material: Thermoplastic Polyester
• Contact Rating: 65 MA

Figure 4. Using the Auto-Window feature for
Banner Engineering Corp.
Position
Position
www.bannerengineering.com • Tel: [phone]
Output OFF
- 5 mm
- 5 mm
Output ON
Normally Open Operation
Normally Closed Operation
programming each output
• Push and hold the
• Position the target for
• “Click” the push button
• Without moving the
...
...
push button
the center of the window
target, “click” the
push button again
Taught Position
Taught Position
Output OFF
Output ON
...
...
Push Button
•
Minneapolis, MN U.S.A.
Output OFF
Output ON
Position
+ 5 mm
Position
+ 5 mm
D
D
...
U-GAGE
...
Procedure
Teaching the same limit twice for the same output automatically centers a 10 mm
window on the taught position.
General Notes on Programming
• The sensor will return to Run mode if the first Teach condition is not registered
• After the first limit is taught, the sensor will remain in Program mode until the Teach
• To exit Program mode without saving any changes, press and hold the programming
Figure 5. An application for the Auto-Window feature (retroreflective mode)
• No action required; sensor is ready for
• Position the target for the center of the
• Single-pulse the remote line
• Without moving the target,
within 120 seconds.
sequence is finished.
push button > 2 seconds (before teaching the second limit). The sensor will revert to
the last saved program.
first limit teach
window
single-pulse the remote line
again
Sensor
Sensor
Output
Output
OFF
ON
™
D
0.04 sec. < T < 0.8 sec.
or
or
S18U Series Sensor — Discrete Output
Remote Wire
Teaching Limits Using the Auto-Window Feature
Range
Near
T
T
or
T
T
Any object in this area will switch
the output, whether or not the object
returns a good signal to the sensor.
Sensing Distance
Output OFF
Output LED: ON Red
Power LED: ON Green (good signal) or
Power LED: Must be ON Green
Output LED: Flashing Red
Output LED: ON Red
Output LED: Yellow or OFF
Output LED: Flashing Red
T
T
T
T
T
T
T
T
T
T
T
T
ON Red (no signal)
Teach Unacceptable
Teach Unacceptable
T
T
T
T
T
T
Teach Accepted
Teach Accepted
T
T
T
T
Result
T
T
Position
-5 mm
T
T
(background surface)
Taught Position
P/N 108964 rev. A
Output ON
T
T
T
T
T
T
T
T
Position
+5 mm
T
T
5