SX100GD2 SENSYM, SX100GD2 Datasheet
SX100GD2
Specifications of SX100GD2
Related parts for SX100GD2
SX100GD2 Summary of contents
Page 1
... This product is packaged either in SenSym's standard low cost chip carrier "button" package, a plastic ported "N" package or a dual inline package (DIP). All packages are designed for applications where the sensing element integral to the OEM equipment ...
Page 2
SX Series Pressure sensors PRESSURE SENSOR CHARACTERISTICS (V = 5.0 ± 0. °C, common-mode pressure = 0 psig, pressure applied to P1 for Button, N and A2 s amb housings, pressure applied to P2 for G2 ...
Page 3
TYPICAL PERFORMANCE CHARACTERISTICS Specification notes: 1. Span is the algebraic difference between the output voltage at full-scale pressure and the output at zero pressure. 2. Hysteresis is the maximum output difference at any point within the operating pressure range for ...
Page 4
SX Series Pressure sensors MECHANICAL AND MOUNTING CONSIDERATIONS Button sensor element The button sensor element was designed to allow easy interface with additional cases and housings which then allow pressure connection. The device can be mounted with an o-ring, gasket, ...
Page 5
APPLICATION INFORMATION General The SX family of pressure sensors functions as a Wheatstone bridge. When pressure is applied to the device (see Figure I) the resistors in the arms of the bridge change by an amount ∆. Figure I. Button ...
Page 6
... TC, hence resistor added to reduce the total circuit TC. The basic design steps for this method of temperature compensation are shown below. However, please refer to SenSym’s Application Note SSAN-16 for details on the temperature compensation technique. Figure IV. Constant current span TC Compensation α ...
Page 7
... R p for temperature compensation and span are 2k more economical for a particular application. 2k SenSym does offer devices with this feature. 2k For more information on these factory 5k calibrated and compensated devices, the 2k SCX series and SDX series, please contact 5k Sensortechnics ...
Page 8
SX Series Pressure sensors PHYSICAL DIMENSIONS Button package mass package mass 8/10 dimensions in inches (mm) dimensions in inches (mm) July 2008 / 052 www.sensortechnics.com ...
Page 9
PHYSICAL DIMENSIONS Basic sensor DIP "D2" package mass Basic sensor DIP "D4" package 0.550 (13.97 0.135 (3.43) 0.250 (6.35) 0.600 (15.24) mass July 2008 / 052 0.470 (11.94) 0.050 typ. (1.27) 0.090 typ. 0.300 ...
Page 10
... SenSym and Sensortechnics reserve the right to make changes to any products herein. SenSym and Sensortechnics do not assume any liability arising out of the application or use of any product or circuit described herein, neither does it convey any license under its patent rights nor the rights of others. ...