ADNS-5700-H3MB Avago Technologies US Inc., ADNS-5700-H3MB Datasheet - Page 30

• Manufacturer Part Number: ADNS-5700-H3MB
• Description: USB SoC 3B Optical Sensor
• Manufacturer: Avago Technologies US Inc.

Specifications of ADNS-5700-H3MB

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Set_Address
Default:
Addressed:
Configured:
Notes:
Set_Configuration
Default:
Addressed:
Configured:
Notes:
Set_Interface
Default:
Addressed:
Configured:
Notes:
Set_Protocol
Default:
Addressed:
Configured:
Notes:
Set_Feature_Device
Default:
Addressed:
Configured:
Notes:
30
00 05 xx 00 00 00 00 00
xx = new device address, from 00 to 7F
Accept
Accept
Accept (undefined in USB Spec)
Chip gets new address, but stays in ”Configured” mode.
If device is not configured, the device will be given the new address and put in the addressed state
(or default if new address=00). If the device is already configured, the device will be given the
new address state and remain configured.
00 09 xx 00 00 00 00 00
xx = 00 = not configured
xx = 01 = configured
Accept (undefined in USB Spec)
Accept
Accept
Invalid config values will cause stall. Chip will stall invalid value in configured mode, and leave
device in old (configured) mode.
01 0B 00 00 00 00 00 00
Stall (undefined in USB Spec)
Stall
Accept
Mouse has only one valid interface (00) and alternate setting (00). Invalid values will cause stall.
Chip retains previous (valid) interface state after executing this command in configured mode
even if invalid values are given and command was stalled.
21 0B xx 00 00 00 00 00
Accept (Not in USB Spec)
Accept (Not in USB Spec)
Accept
3 byte data packets will be reported in boot mode. These bytes are button, XX data, and YY data.
Tilt wheel botton 7,8 will not be reported
00 03 01 00 00 00 00 00
Accept (undefined in USB Spec)
Accept
Accept
This sets the remote wakeup bit.
xx = 00 = Boot protocol
xx = 01 = Report protocol