USB Evaluation Board

USB-EVAL

Manufacturer Part NumberUSB-EVAL
DescriptionUSB Evaluation Board
ManufacturerHEXWAX
USB-EVAL datasheet
 


Specifications of USB-EVAL

Silicon ManufacturerFirmWare FactoryKit Application TypeInterface
Application Sub TypeUSBFeaturesRS485 Line Driver, Coin Cell Battery, SPI Serial Memory, 28-Pin DIL Host Processor, 3 Jumpers
Lead Free Status / RoHS StatusLead free / RoHS Compliant  
1
Page 1
2
Page 2
3
Page 3
Page 1/3

Download datasheet (3Mb)Embed
Next
Summary
The USB Evaluation Board is a circuit board for
evaluating USB products from Firmware Factory. In any
given evaluation, only a small proportion of the
components will be fitted. For this reason it is supplied
unpopulated and uses through-hole components for
easy manual construction.
Compatible USB Products
The evaluation board is compatible with the following
USB products from Firmware Factory:
 USB-232 asynchronous serial interface
 TEAleaf-USB security and authentication dongle
 expandIO-USB I/O expander
 USB-SPI synchronous serial interface
 USB-I2C synchronous serial interface
 USB-TakeOff managed power take-off, wakeup
and charge controller
 USB-DAQ data logger
 USB-FileSys configuration and diagnostic module
To use the evaluation board with each of these products,
please refer to each product’s individual data sheet.
p1
3-Sep-08
USB Evaluation Board
Features
The board provides for:
 20-pin, 28-pin and 40-pin DIL devices
 Type B socket, suitable for standard USB cables
 Type A plug, suitable for USB extension cables
 12MHz and 32kHz crystal oscillators
 RS232 line driver, 9-pin sockets in DTE and DCE
configurations
 RS485 line driver
 Coin cell battery
 SPI serial memory
 28-pin DIL host processor
 3 active low LEDs
 3 active high LEDs
 3 jumpers
 Photodiode
 Thermistor
 Li-Ion charge controller
 Prototyping area
USB Evaluation Board
HW157-3
Firmware Factory Ltd
rd
2 Marshall St, 3
Floor
London W1F 9BB, UK
sales@firmwarefactory.com
support@firmwarefactory.com
www.firmwarefactory.com

USB-EVAL Summary of contents

  • Page 1

    ... Summary The USB Evaluation Board is a circuit board for evaluating USB products from Firmware Factory. In any given evaluation, only a small proportion of the components will be fitted. For this reason it is supplied unpopulated and uses through-hole components for easy manual construction. Compatible USB Products ...

  • Page 2

    RS232 connectors LEDs Jumpers Serial Memory RS232 driver Coin cell Host controller Photodiode MAX485 driver Li-Ion charge controller, thermistor TEAclipper connector for host controller ...

  • Page 3

    ... Crystals USB sockets 20-pin socket TEAclipper socket for USB devices ...