V2-EVAL-EU FTDI, V2-EVAL-EU Datasheet - Page 10

• Manufacturer Part Number: V2-EVAL-EU
• Description: BOARD, EVALUATION, EU PSU
• Manufacturer: FTDI

Specifications of V2-EVAL-EU

• Kit Contents: 1 X V2-Eval Base Board, 1x 5V/1A Mains Adapter PSU, 1x USB A/B Cable, 1x USB Gender Changer
• Svhc: No SVHC (18-Jun-2010)
• Kit Features: VNC2 Embedded USB Host / Slave Chip Accessible Via
• Silicon Manufacturer: FTDI
• Silicon Family Name: Vinculum II
• Features: Embedded USB Host / Slave Chip, Two USB Type A Connectors
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.1.1 Components.
Table 3.1
Component
USB-UART bridge
Configuration memory
IO multiplexer
3.3V regulator
Dual port buffer
Inverter
12MHz crystal
Single 5V DC power
supply
Power switch
Power source select
Reset button
Keyboard
User LEDs
PROG LED
Power LED
UART RX LED
UART TX LED
Debug TX
Debug RX
SPI_RX
LEDs enable jumpers
GPIO I/O Jumpers
REMOTE WAKEUP
VBUS jumpers
V2-Eval Board Components
Copyright © 2010 Future Technology Devices International Limited
Board designator
U2
U3
U4
U1
U5
U6
Y2
CN12
SW1
JP6
SW2
SW3-SW6
LED3-LED6
LED1
LED2
LED7
LED8
LED9
LED10
LED11
JP7-JP10
JP1, JP2
JP3
JP4, JP5
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Description
FT4232H USB  Quad UART/FIFO device.
9356 Serial SPI EEPROM for FT4232H configuration data.
74CBT3257 4-bit, 1to2, FET Multiplexer/Demultiplexer.
AIC1735-33 Ultra low dropout 3.3V voltage regulator.
SN74LVC2G125 dual port buffer used to convert bi-
directional debug signal into separate TX and RX signals.
SN74LVC1G14 inverter device used to invert the TXDEN
output from FT4232H to control output enable signal for
dual port buffer.
12MHz crystal for FT4232H.
Board adapter for included 5V DC power supply.
Power On/Off switch.
Power source selection jumper.
Push-button switch for manual reset of VNC2 device.
Four user push-button switches.
Four green user LEDs.
Red LED.
Green LED.
Green LED.
Red LED.
Red LED.
Green LED.
Green LED.
Enable/disable user-defined LEDs.
GPIO I/O jumpers .
VNC2 remote wakeup jumper.
USB1, USB2 power bus enable jumpers.
Document Reference No.: FT_000247
Clearance No.: FTDI#148
9